tak ade.
bukak your alarm module at your boot.
remove 1 wire that ori plug to car, tap into the OEM ABL (its a relay actually) then the output wire from relay back to car/alarm module.
I dono the actual steps because accessory shop did for me but no wire cutting and etc.
only 1 wire from car/alarm module plug into relay, relay output wire plug back to car/alarm module.

Pak zeone did DIY his OEM ABL installation.
I did not 

have to make sure its OEM lor.
otherwise if universal type, then need to cut wire.
and also drill hole I belib

this one nearer, you can go hab a look.

better than Penang 

can also 

if you need reference, I rmb pak zeone got post before his DIY steps in older tereds.

 

Hi Bro Eric...

Yup, me got my OEM ABL Module (fr Bro Sh@rty5) years ago when my Gaga still new that time...
And yup, it's like Bro ruby1288 posted...
That module is PnP ie uplug cable 2Alarm & plug in2 ABL socket; plug in plug fr ABL in2Alarm socket.
Only 1 cable need 2tap in2 power cable 2rear brake lamp...
That's it!

Mine is in a solid plastic box whereas the module yu show above is a PCB in shrink wrap only but same install...can see the lone cable 2tap in2 rear brake line.
Mine is however also more expensive... 

Yr choice, Bro...

How you check the bars in the doors and seat belt pretensioner?    have to dismantle door and B-pillar to check those things.

But if don't have the V-bar in the boot behind the rear seats and the 3-point rear middle seat belt, then likely it's pre-SV model.
xyah.

Other auto cars maybe need, FLX CVT no need.
My FLX SE also ade, but you nvr notice even though you saw my car more times than you saw ruby's

I haz a sadding 
DIY TB PnP also  titanrev

i buat kat accessori shop aje, together with my Locktech.
GLS Auto @ USJ.

But LYN got member sell also.
In Klang, I belib.
ID = Sh@rty 5
i dont have his link selling the OEM ABL but you PM him, he should know.
few members in saga club bought from him including dares (IINM).
IINM, dares or kenjilew got lubang for OEM ABL ?

berape

26 is labour fee ma.
u DIY ma labour free lor

i got mine for less than that @ericmaxman

Persona 4AT cannot.

ericmaxman mau DIY PnP TB ah....very easy one....if never do before don't use DREMEL or power tool 1st because will easily screw up if hand not steady. Hand more slower and take more time but reduce chances of screwing up the TB. Remember our TB is DBW so don't soak it in cleaner or degreaser. Just spray some on old rag then wipe clean bit by bit even for PnP job.....then use compressed air to blow clean.

mana mau jumpa na2. and dun have 200k cash lying around lol