Actually what is the purpose to add this? My last service also they added it for me. Improve performance?

Another question:
My gear indicator light at the gear console is gone. At night my gear console is dark. Normally when turn on headlamp, the numbers will light up. Been complaining about this since the 3rd service, but never entertained. Always told me not enough time to take out and check. Until last service, finally they checked for me, and informed me the bulb is burnt, need to change.
Problem is: Bulb x1 = Rm5.++ <- ask me to pay. ok, nvm, only RM5.++. no big deal.
BUT: Labour charge = RM 50.++/ hour x dunno how many hours <- this also ask me to pay!

Is this normal? My car is still under warranty period, and its not as if i made the bulb spoilt. It was spoilt before my 3rd service! Ask me to pay for the bulb, is already stretching the limit, now even the labour fee to change the bulb also have to pay? Correct ka? If correct, then i diam diam bring to change lo...

avoid Shell pls...

tak boleh claim warranty? since under warranty period shud b able to claim gua... unless it is categorized under wear and tear item... bulb ma...got lifespan one...

so not worth to put in? my friend told me if pour into big engine only worth.

I always pump shell @@, last time pump petron once, but didn't feel any different.

my friend study about petroleum also say shell not good, said esso was the best, but that was during cny meet up last time,I forgot was it this year cny or last year

how come your car engine fan can turn on after u switch off engine?

anyone know how to remove the center piece of dashboard right above the center aircond vents?

TDUEnthusiast, need ur advise since u did DIY before...

This post has been edited by ckdenion: Sep 26 2013, 10:30 AM

not to say not worth to pour in...after all, it is for engine protection...consult kennywee92. i nvr use before cant comment much on that...

i avoid shell... prefer Caltex the most followed by BHP then Petron/Esso

same as mine, gone.haven do anything to it yet.

u want add turbo there?

I have no idea what is that for, based on logic should be block the air intake only. Not sure what else.

You should go to another SC, then ask to change the bulb. I also kena this labour charge before. My even worst, no part need to replace, just ask them to check the sound, end up just 1 Nut have to tighten it up, that also I'm the one let them know where the sound come from. End up charge me labour...

Right after I never visit that SC again, went the other SC they didn't charge if under warranty.

http://amirjusoh2.blogspot.com/2012/01/diy...-dashboard.html

yes...do some air suction device underneath to increase air flow to the manifold...

thanks! nice simple guide for nuff like me...

ok, then I just clean it with water la.

How long since you last service your air-cond? At what mileage then compared to now?

Sorry, never open before. Just put double sided tape under the knobs of the air-cond so they will not be so loose and make kring kring kring noises. I still suffer from sand like noise in the air-cond system though, so prolly have to open up the whole dashboard. I think I'll do it when I finally get around to being able to afford soundproofing materials


Thanks for this link. The TS should have it put on the first page.

how much budget u plan to spend on sound proof? and what area? I notice sh@rty sound proof quite cheap

Many ppl are preferred Caltex and BHP for the performance of the car..
Why does you avoid Shell ?

No budget kos I poor ploton usar.

Didn't mean to go against you. But you pour in even before 5, , 000KM. I think that's the reason.

Could be. And assuming if it sticks for 50000KM, it's still effective in my engine now. My engine is still quiet silent despite high rev often. Maybe it is Ceratec's work.

ppl say no budget when they have unlimited budget

this one real case wan