Jan 13 2014, 01:29 PM
QUOTE(blu3hamm3r @ Jan 13 2014, 09:37 AM)
sp6068: After u read the below list down problem, u judge urself worth or not worth...hahaha...
1. All interior part made by plastic and rubber. Many part need cement glue to stick together. Some more the part after joint still got huge gap.
2. Both seat made by rubber, cant fit nicely with the plastic seat flame. The side rubber is swelling, unless use super glue to glue it. Normal cement glue cant work on it.,
3. Plastic dashboard, black color plastic but not fully black, can see many white color liner cross over the part. Need repaint.
4. Main body made by diecast but side skirt and airvent made by plastic, the color not match between the plastic part and diecast.
5. Lot of step inside the installation manual was wrong or not indicated.
6. Part missing.
7. All 4 wheel height is too high. Big gap between the wheel and car body.
8. Drive shaft coming out from engine is not connected to the wheel, but when finish assembly, when u turn the wheel, the drive shaft will block the wheel to turn and will hit the wheel suspension. U cna hear some more like "tak tak tak" when u turn the wheel.
9. Side skirt srew hole is not match with body screw hole. Cant screw it together and tis had cause a big gap between the side skirt and body. More obvious at the back part.
10. Front bonnet and engine cover cant open evenly unless u use both hand holding both side and open slowly n carefully. Otherwise the cover will stuck n bend.
All that for 2k+? Damn Rather get AA or Tamiya 1:12 man like that. I guess the pocher was meant just for its huge presentation of the Aventador since its the only alternate big scale bull compared to Amalgam's.1. All interior part made by plastic and rubber. Many part need cement glue to stick together. Some more the part after joint still got huge gap.
2. Both seat made by rubber, cant fit nicely with the plastic seat flame. The side rubber is swelling, unless use super glue to glue it. Normal cement glue cant work on it.,
3. Plastic dashboard, black color plastic but not fully black, can see many white color liner cross over the part. Need repaint.
4. Main body made by diecast but side skirt and airvent made by plastic, the color not match between the plastic part and diecast.
5. Lot of step inside the installation manual was wrong or not indicated.
6. Part missing.
7. All 4 wheel height is too high. Big gap between the wheel and car body.
8. Drive shaft coming out from engine is not connected to the wheel, but when finish assembly, when u turn the wheel, the drive shaft will block the wheel to turn and will hit the wheel suspension. U cna hear some more like "tak tak tak" when u turn the wheel.
9. Side skirt srew hole is not match with body screw hole. Cant screw it together and tis had cause a big gap between the side skirt and body. More obvious at the back part.
10. Front bonnet and engine cover cant open evenly unless u use both hand holding both side and open slowly n carefully. Otherwise the cover will stuck n bend.
Quote
Spam yo collection! 
4mm double sided tape? Y dont u use ultra think double sided tape?
0.0371sec
0.72
7 queries
GZIP Disabled