samsung UCCC can do DDR550 at loose timing as mine here...

erm.. TCCD in disguise for large module.. nice.. wah.. hand itchy..

tweaking a UCCC is easier than infineon's counterpart...
however, dont expect UCCC to go as high as TCCD..

Mine Team Xtreme BH-5 DDR400 2-2-2-5 running 255MHz @ 3.5V memtest and prime stable. Probably can go a few Mhz higher with higher voltage but runs very hot. Using a Vantec Tornado 90mm to cool it down effectively.

yes...words says that BH5 running very hot....i'm getting the DDR500...eheheh....BH5 is a good investment and a good toy to play

the 2-3-2-5 one
part number have to mess wif my comp again...see if i got time lo

This post has been edited by superpc: May 28 2006, 06:53 PM

i owned team xtreem ddr600, tried 1t on asus board but limited cause asus's 1t issue, now swtiching to biostar tforce series, hoping 1t woudnt be a problem...

i think biostar t-force should be better...since i see a lot of ppl who r using giving good comments.....

anyway, thanks for supporting TEAM

Here is my TeamXtreem 2x1GB DDR500 Samsung UCCC result :

hehehe nice result. try tightening abit the timing.

my pair is 2x1GB RAM leh..
don't think got other timing can be tighten liao gua ...
if got also that TWR timing lor

hehhe.... my kvr 1gb BT-D43 can do 3-3-3-8 @250. Too bad, just 1 stick though.

Not every UCCC RAM able to do tight timing ma (example :3-4-3-x)
so i satisfy with it lor

consider UCCC as higher density TCCC only

TCCC also not consistent, but mostly can do 250mhz.

Fast test SuperPI 8M TeamXtreem 2x1GB DDR500 Micron @ DDR540, 3-3-3-8,1T, 2.7v :

testing Team Xtreem DDR2-667 3-3-3-8 2GB Kit

DDR2-1072 4-4-3-1 @ 2.5 volt









nice memory indeed

and price is quite cheap compare to other performance DDR2 as well