Looks nice. You can never go wrong with a tj07
Can I suggest maybe putting it on a picture hosting site like photobucket or flickr so that the image is large. It's hard to see small pictures.
project a-noob-is-here, temjin tj07 watercooled
|
|
 Jul 6 2013, 01:15 PM
Return to original view | Post
#1
|
 
Senior Member
660 posts Joined: Jan 2012   
|
|
Quote|
|
|
|
|
Jul 14 2013, 10:06 PM
Return to original view | Post
#2
|
|
Senior Member
660 posts Joined: Jan 2012
|
May I suggest when you cut the fan controller or anything that requires cutting without precision. cut from the inside to the outside of the case so you can just spray paint inside the case so that it is less visible on the outside.
Anyway, love that update. keep working, man. |
|
|
Jul 14 2013, 10:35 PM
Return to original view | Post
#3
|
|
Senior Member
660 posts Joined: Jan 2012
|
QUOTE(pali_5373 @ Jul 14 2013, 10:18 PM) hitam+putih+kelabu asap jerebu.. u inspired by haze arh?extenders yg kale itam tu nk spray kale putih..  |
|
|
Jul 19 2013, 06:19 PM
Return to original view | Post
#4
|
|
Senior Member
660 posts Joined: Jan 2012
|
QUOTE(infernoaswen @ Jul 19 2013, 10:57 AM) Yeah I know. I am asking what is the accessory that came with the flowmeter for, because there isn't any proper explanation from bitspower about the purpose or which to use Yea, most BIOS will give you error that says "CPU Fan Error" and ask you go to bios.I also think so, I did a little research. Some say that some motherboard gives warning if the RPM speed is too low, so the conversion is to make it spin faster at higher RPM so you wont get that warning in the bios. Before this I didnt use any of the flow converter, there was a small leak. I had to tighten the fitting with piler super tight till no leaks, then I bleed & insert a 8mm converter & tighten with hand. No leaks so far & the blade do spin a little faster. Just sharing my experience with it  I am afraid to use the 5mm set, scared later too much restriction in the loop  to avoid that, is go to bios and go to tab that monitors your cpu fan and put everything as ignore. It saves time since you're using water-cooling and I hope that you are using somewhat a fan controller since you can afford 3x gtx670. Anyway, love the ..... curry puff. Don't know about the build though. |
| Change to: |  0.0187sec
 0.77
 7 queries
 GZIP Disabled
Time is now: 18th December 2025 - 11:00 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.