QUOTE(rihuhs @ Aug 1 2013, 10:03 AM)
I'm no master, what I usually do is;
- cut the part from the runner, leaving about a few mm of nub
- trim the nub with cutter, this time with a closer cut but not fully removing it out
- trim the remaining with a knife, making a clean cut
- touch it up with markers. for dark areas, grey sometimes works best
here's how it looks after being cut, before trimmed with a knife and touch-up:
and here's how it looks after being trimmed and touch-up:
but then actually trim like that still visible or not? i duno haha- cut the part from the runner, leaving about a few mm of nub
- trim the nub with cutter, this time with a closer cut but not fully removing it out
- trim the remaining with a knife, making a clean cut
- touch it up with markers. for dark areas, grey sometimes works best
here's how it looks after being cut, before trimmed with a knife and touch-up:
» Click to show Spoiler - click again to hide... «
and here's how it looks after being trimmed and touch-up:
» Click to show Spoiler - click again to hide... «
i normally use fingernail scratch till the white gone
lazy spend much time to trim
This post has been edited by Agito666: Aug 1 2013, 10:36 AM
Aug 1 2013, 10:36 AM


Quote










0.0452sec
0.80
7 queries
GZIP Disabled