Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

 Biostar Tforce 6100 Overclocking Discussion, Biostar Tforce 6100 modded bios inside!

views
     
charge-n-go
post Apr 29 2006, 04:11 AM

Look at all my stars!!
*******
Senior Member
4,060 posts

Joined: Jan 2003
From: Penang / PJ

My roomie was using D43 previously. He can go up to DDR480 2.5-4-4-11 1T @ 2.7V only. Well, he was using DFI nF2 Ultra Infinity la, maybe u can give a try on this setting.
btw, the Trc / Trfc = 13/15 if not mistaken.
charge-n-go
post Apr 29 2006, 11:38 PM

Look at all my stars!!
*******
Senior Member
4,060 posts

Joined: Jan 2003
From: Penang / PJ

change to X1600Xt lo, hahaha
charge-n-go
post May 12 2006, 12:56 PM

Look at all my stars!!
*******
Senior Member
4,060 posts

Joined: Jan 2003
From: Penang / PJ

QUOTE(shadow_dweller @ May 11 2006, 12:52 PM)
wanna ask all those sifu here. my system is prime stable at 2300Mhz for 7-8 hrs and i'm using a 6600gt at stock but why my computer will hang when i play dota half way. if i lower my cpu speed to 2250Mhz or below it will be fine. 
i'm quite certain the problem is my cpu causing the problem but isn't it suppose to be rock stable after it pass prime tes for 8 hrs ?

setting
htt = 230
multi = 10
ram = 2.5-4-3-8 ( okie i know it's abit tight for bt-d43 but even if i set it to 3-4-4-10 the same thing happen )
wanna ask what you guys set for the read preamble time and mas async time ? for hte max async time anythign above 6 and it's no post for my mobo. weird. and i tot it's suppose to be more stable if you set it around 8
*
yo dude, even my system has this problem.
I think most probably the 12V rail is not very stable or not enough power.

For my liberty 400W, priming at 2.85GHz 1.52V is absolutely stable, and 12V rail has about 11.78V. However once I gaming for a few hours, i noticed the 12V rail drops to 11.40V only (using MBM high/low interval to check). Got 2 times i run 3D mark 03 half way and suddenly hang at that speed, so i guess the 12V rail might fluctuate too much until below 11V.

Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0242sec    0.40    7 queries    GZIP Disabled
Time is now: 6th December 2025 - 09:48 AM