1st page?

vapor production?

flavor?

standard airhole?

your mod please...

what is your chobra resistance?

less vapor with the cap on right?

can u taste the flavor?

no wonder, your only stacked batteries can solve this issue, kekeke..

wash ur mesh, torch it again, recoil again..

for lavatube, try to get range between 1.6ohm to 1.8ohm..

32awg kanthal with 5 wraps should be ok..

k100 org dh mula buang harga, complete set skang paling murah rm150 baru...

vv/vw still atas rm200 klu baru tp worth the investment...

cmni...

utk RMS, output power lebih accurate, ko set 4.0v, max dia akan tembak pun 4.1 or maybe 3.9v..

sbb calculation dia ambil resistance coil, output level and amp limiter..

utk AVG, ko set 4.0v, dia maybe akan tembak 4.5v...

pastu ko fire lg maybe akan tembak 3.8v...

so, dia akan tembak within that region, pastu akan avg kan, even ko set 4.0v, avg 4.2v, dia akan fire constant 4.2v plak lps tu..

so, RMS lg better, at watts or volts..

klu ko tgk vaping chart, 2.0ohm max 4.0v/8watts..

higher than that, kemungkinan untuk burnt taste tu ade...

tp, ade faktor lain even ko fire 10watts pun x burnt taste..

wicking kene cantik, liquid pun main peranan...

so, jgn assume guna RMS tembak tinggi x hangit ye..

aku guna dripper 1.4ohm, tembak 10watts mmg x hangit within 5-6saat drag..

1.4ohm max klu ikut chart dlm 3.4v/7.7watts je..

reason, aku wat juice catcher, wick 5 lapis, liquid 70/30...

klu 50/50 bleh drag lagi lama..

This post has been edited by duke_hunt: Apr 12 2013, 05:21 PM

9.9ohm ade 2 je, coil short atau tank connector kt thread tank x kena kt center pin vamo..

kuis center pin vamo guna paper clip ke, skru driver yg kecil bagi naik..

then skru balik tank agaT ko..

klu still kuar 9.9ohm, recoil balik...

klu boleh, cari Smok RSST, harga lebih kurang dgn aga-T2 tp tank plastik...

mesh hole insulated, so utk kebarangkalian utk short tu kurang..

kebarangkalian utk hotspot ttp ada...

klu x salah aku efest hitam ni protected..

shud be no issue kot..

standard 18650 about 6 hrs charge time on cap ayam charger..

18490/500 shud be around 5 hrs charging time and 18350 around 4 hrs..

charging time may vary on charger type and also drainage level..

higher drainage on mechs as x bleh tgk battery level while on vvw devices, cuts off at 3.2v..

i normally charge when my battery is at 3.4v-3.5v...

3.2v when i recoil...

normally lps recoil sure battery aku drop smpi 3.2v and dh x bleh fire...

yg mane battery dh tinggal 3.5-3.6v, klu ade keperluan utk recoil, aku guna battery tu utk recoil..

bila abih, charge le...

the trolling here is strong my dear padawan..

hahaha..

sure your full setup got some sort of hour glass figure..

KTS and DS Mod are bottom side firing while K100 and Sentinel Clone both are direct bottom firing..

performance wise, different for both settings.

better choice would be bottom firing but if u can, have a go with all devices...if not, K100 is full proof..

some say sentinel clone performance not bad either..

for KTS, u need to tweak all contact point to minimize misfiring issue..

as for DS Mod, try and get the copper/brass contact point..