lots of ways.. but I would recommend to meet up to teach, would be easier that way...

anyway below is from my previous post:

celicaizpower, on 03 Jun 2013 - 4:33 PM, said:

Here are some tips to re-coil Genesis tanks yang orang biasa buat salah.

1. Mesh terlampau padat. (either bagi lubang kat tengah atau cuma wrap 3/4 dari lubang yang mesh tuh masuk), aku punya kiraan for mesh is normaly 7cm * 3.5cm.
2. Kanthal terlampau ketat. (Kanthal kena longar, dia cuma patut just touch the mesh je dan bukan hug the mesh)
3. Properly oxidise (burn) the mesh and kanthal.
4. Distance + pole ngan mesh (kena rapat, sebenarnye kalau mesh touch the pole pun takpe, janji kanthal lain tak kena, kalau tak nak mesh kena pole, letak je washer dan pastikan kanthal pun kena washer all the way dari +pole sampai mesh)
5. Kanthal Ribbon is the best to use for re-coiling Genesis. (no doubt wire pun boleh, tapi ribbon is the easiest)
6. Only adjust the kanthal that is not lighting. those yang menyala means the current is running till there and then gets blocked. so adjust those that are blocked or not lighting.
7. The lesser the loop the easier the setting. Go for 3-4 loops, it's the easiest. But if you are using Voltage variable device, go 5-6 loops so that the VV can detect and fire.
8. When using VV to re-coil, set the voltage to 3.0 or 6.0 watts. When using a mech mod to recoil, use an almost flat battery.
9. Mesh touch bottom tank. (make sure mesh tak touch bottol tank, this might cause shorting depending on the type of the tank)
10. Bila dah semua kat atas dah ngam, fire and while firing adjust those yang tak menyala in short burst mode (not more than 3 seconds)
11. Patience & Practise makes perfect.

hope this helps you bro.

[/quote]