there were 2 original brackets that was one part of the structure of the original shocks, but with the titan shocks both were gone and they used just a wire/spring and cable-tie to secure it
can see the round rubber mount still attached to the hose but is hanging in midair also...


from another angle...

i guess this applies to only the full setup, anyone of u guys noticed this?
supercircuit technician say maybe in danger of the brake lines rubbing against the spining driveshaft or moving tyres.. zzz

here's the front, unlike what Titan did which was simply hooked on the brake hose with a couple of wires and cable-tie, Sanchez who personally installed the new lines did a good job securing it to the shocks by making a DIY bracket.


this is the rear top cable


the rear bottom cable

initial feel is that the brake pedal bites earlier when stepping on it, estimation around 5mm earlier at least, and the progression while applying brake pressure is more linear and accurate.
the dead pedal feel of the first 1cm is still there but i think it isn't a bad thing, never liked the feel of those small japanese car brake pedal where it's overly sensitive from the top of the pedal touch abit also will brake jerk

so far feels good, need some proper hantam-ing to conclude tho

This post has been edited by l3ryan: Apr 9 2013, 12:46 AM