Lowyat.NET -> Garage Sales -> Special Interest Garage Sales -> Home Electronics & Wares Garage Sales[WTS/Bulk] ▲★ CAL-LAB Lightning Isolators ★▲, Authorised Seller@Performance Guarantee
|
|
 May 31 2008, 03:39 AM
Return to original view | Post
#1
|
 
Newbie
0 posts Joined: Dec 2005 
|
Hi Gan,
My modem just got struck few days ago and I'm looking for a protection for my new all-in-one broadband modem. So SF9512DSL-MS2+3 will be good enough for this? Will it still work the same if I plug it into the existing extension? |
|
|
|
|
|
May 31 2008, 11:31 PM
Return to original view | Post
#2
|
|
Newbie
0 posts Joined: Dec 2005
|
My router is about 3-4m away from my pc (within the same room, I put it near the center of the house for better wireless reception at downstair) and it's only connected to a single PC through the LAN. Does that mean that I need extra item to protect the LAN route? If that's the case I might consider to move the router near to the PC since I'm in tight budget now.
|
|
|
Jun 3 2008, 04:20 PM
Return to original view | Post
#3
|
|
Newbie
0 posts Joined: Dec 2005
|
Hi Gan,
I think I'll place the router somewhere near my PC, but will the spike come from the LAN port if my PC is left unprotected (if I plug it to my router only)? My router is using a 2-pin plug only, so if I plug both my router and CPU (single 3 pins) to the cal-lab unit it'll protect both of them right? Btw, what does it mean by +SKPX (i.e difference between SF9512DSL & SF9812DSL)...I noticed that the brochure wrote about the small module but I still don't quite get it. QUOTE(gkl83 @ Jun 1 2008, 04:49 PM) if ur wireless router connected to single PC thru lan cable, and u relocate the router near ur PC... SF9512DSL or SF9512DSLMS2+3 or SF9812DSL will be fine... yes... if u insist to protect tel line only, then u take the responsibility that ur modem may get damage too if surge come from power line... is no caused by cal-lab units failed to protect tel line...  |
|
|
Jun 9 2008, 04:13 PM
Return to original view | Post
#4
|
|
Newbie
0 posts Joined: Dec 2005
|
I'll get one SF9512DSL-MS2+3 then...where is it convenient for you to COD? I'm staying around Cheras UCSI there. How much extra charge if I choose delivery through postage? QUOTE(gkl83 @ Jun 3 2008, 04:35 PM) yup... u must ensure ur router, CPU, monitor, speaker, printer, scanner, and other equipments which inter-related must connect all on cal-lab units... assume there have wrong installation, all equipments plugged on cal-lab except speaker power source come straight from wall socket... if lightning surge come from power line and it will go thru ur speaker, it surge able to bypass into audio jack and ur mobo may damage by surge too even ur CPU plugged on cal-lab units... for the correct ways are speaker must connect onto cal-lab too... SF9512DSL doesnt come with SKPXDSL module... if it tel module dead, u have to replace whole units which cost u RM25... SF9812DSL come with SKPXDSL module... if it tel module dead, u have to replace the SKPXDSL only which cost u RM10... but if 9812 power module dead, u have to replace whole unit which cost u RM25... |
|
|
Jun 11 2008, 04:13 PM
Return to original view | Post
#5
|
|
Newbie
0 posts Joined: Dec 2005
|
Item received! Paid on monday night and received it this morning. ::thumbs up::
Oh ya Gan, where should I ground the hanging wire? I'm going to ground it to the main socket, but would it spoil the unit if i ground it to the CAL-LAB unit? By the way, there're two LED indicator near the phone jack. How can I interpret the signal? If one of them is off means the unit is dead? Where can I send the unit to fix if it's spoil? Is there any CAL-LAB distributor around Cheras? This post has been edited by YS_yongmou: Jun 11 2008, 04:14 PM |
|
Topic ClosedOptions
|
| Change to: |  0.0443sec
 0.33
 7 queries
 GZIP Disabled
Time is now: 29th November 2025 - 01:37 AM |
Quote