QUOTE(RacingTech @ Mar 31 2006, 01:29 PM)
I using the default voltage at 2.65v because i heard Samsung dont like high voltage so i didnt push it higher.

QUOTE(e-jump @ Today, 04:16 PM)
memtest86 n blowing fans comes in handy
u need to try it urself to check whether ur set likes extra juice, or craps out with juice

bare naked RAM is better, and adding a fan to blow around it will definitely much better

somehow i am still sceptical about the heat transfer provided by thermal tapes. i don't see how well it does the job.... doesn't look like it can absorb the amount of heat and transfer it to the heatspreader effectively.

heatspreader will be very efficient if there weren't any thermal tape used, and the heatspeader touches the chips directly... just like a heatsink on a cpu.

Thanks for your complement lichyetan ,  my cpu is also venice core but may be i'm not lucky enough to clock it high with default heatsink. I am thinking of getting a good heatsink like ninja n see how it perform. As for the RAM, i think it is good enough for me, but like zahri say, is like possible for use to use thermal paste on the heat speader n removing the default thermal tape??? Is any one out there try that before???

i just can think 1 solution if u guys going to use heatspreader for the rams. Use non-conductive aka mx-1 thermal grease.

It's sure look goods, but, heatspreader are meant for high vdimm one aka bh5 / ch5. Ive been running my bt-d43 253@2-2-1-11 1T 2.9v back while. it didnt get hot ( as hot as need some cooling ).

Just my 2 cents.

hehehe..just xtra 0.2 v to gain20 Mhz more..btw till now i never heard someone burn their hynix ram when apply 2.9 v voltage

Looking to the D43 datasheet, 2.7v is the limit. but, oh well. with 2.7v managed to get around 230-235 onli. n 2.9v 253.... i choose the later, LT warranty summore.

He said "till now i never heard someone burn their hynix ram"