I have tried it and I confirm it works. My Blitzwing zero problem now. Shoulder hinge locks into place and is tight.

This post has been edited by jhcj: May 13 2013, 09:40 AM

So long didn't check in here... feels like a kid when back here

yeah blitzwing has a very squared out look, as opposed to springer which has a more sleek silhouette.. to each his own though, i think both of them are fantastic.. no time to fix blitzwing's shoulders yet though, will get on it later in the week

Beautiful pictures of Springer here.
Hope I can get mine soon.

Anyone fix the blitzwing's shoulder yet? Prefer to fix the shoulder without sanding

u can give this one a try.. however i doubt it's as permanent as sanding down the parts

if that's the case, might as well use hobby putty.

yeah when i watched the video i was thinking hobby putty would be easier.. but i want to wait till i have time and sand down the plastic for a more permanent fix

dah biasa gunpla should be no problem fixing

This post has been edited by HxiiiK: May 13 2013, 10:25 AM

another cheaper method is to use nail polish, but this require technique and a steady hand.

sanding the plastic - not for the faint hearted.
hobby putty - the easiest method (for me la)
nail polish - require calm n steady hand technique.

if the plastic is too thick that the shoulder joing cannot connect, i think nail polish will not help either, since it won't be nearly thick enough to reach the other side hobby putty will work but u leave an ugly blob inside the shoulder area.. not obvious, but u know it's there therefore, sanding is the best way to go.. go practice

quality nail polish will work la. but must put a lot of coatings n dry overnite in between coating.
sanding is the best method yes, but to those who never do b4, sure cacat la. begineers better buy some KO TFs to do some practice first.

i was thinking after getting hexatron want to .. in stasis for a while.. tgk2 got springer and blitzwing (

how can i retire in peace

nvm retire can always come back again. then retire again, then comeback again..

will hasbro make Tripticon?

tripticon then retire come back again lagi.. neverending cycle

well, u can start with,

1. remove all your hobby / toys related fav. links
2. stop visiting hobby / toys related thread
3. remove all your collectors friends from FB or switch off their updates on news feed. each one of em..
4. avoid going to hobby / toy shops

goodluck.

wah, ni boleh jadi tok guru TFs.

duduk dalam gua, makan sayur saja. meditate. free your life from TFs.

sanding the tf isnt that bad

just sand bit by bit if scared, but this is more time consuming

sand abit, fix back, see if shoulder hinge locks into place

if not, open back, sand again abit

repeat till satisfied

then.. if rasa2 xbley tahan / lawan nafsu, sila lupakan untuk "quit" dan teruskan perjuangan mengumpul koleksi tf anda ~

1 day without TFs still can tahan. 1 week oso still can tahan.

But who can tahan 1 month no TFs? can tahan or not? nafsu TFs mmg kuat.. can see but cannot touch..