Bcoz you said you're serious, so I actually went and check gold price just now

Already said so many times, change oil regularly I know why lar, bcoz I'm not EricTheCarguy, ayam DavidTheSohigh

At where? Eat what wor? Got anything RM12 geh mou. Not enuf bajet lar

20 bucks sounds acceptable. When wanna play? I oni cum bak 13th, if time allowed I will join

Managed to find 10mm lug, but slightly more expansive. Save up cost for 10-15mm X 4pcs washer, overall costing should remain the same. Discussed with bangala, they will do the labor for RM0.50/set of "crimping" process(ayam not going to stay home and hammer all the bulk cables, cutting insulation itself already pain in the butt finger). Couldn't find suitable shrink wrap, might need coolkwc advice. Current measure, I use wire tape to cover only. Overall costing should stay at RM19.00/unit.

So, if DIY, cost stays at RM18.50. If let bangala do, then its RM19.00. What say you guys? Later go home(if sky not dark) snap photo for u guys

Shd be 10mm inner diameter(for battery connection), can withstand 100amp shd be enuf. Cable is 300amp, but its only grounding work, so not neccessarily high amp.

Meanwhile, forgot we need bolt & washer since the engine hook there the hole too big. Size, unknown yet. Will have to go hardware shop again.

Thanks in advance.

Forgot to measure Later bring caliper go check & see Cable is 35mm²

On the side note.... is that how I got in to a big fight with sooooo many peeper

Yes. All the dust got stuck at the paper filter instead of your nose. In order to suck dust with your nose, please remove cabin paper filter

Meet me in Ipork, I'll be home/magician all day DIY. Haus not convenient. Meanwhile, compiling data for next bulk

Any 1 lar, another charity work. No money earn geh

Guys, don't get too excited 1st. Still haven't finalyze, below are list of shorted material:

Mounting point for engine hook
1x 10mm HEX bolt
2x 10-15mm washer
1x 10mm HEX nut

For cable end
15mm diameter shrink wrap - pending V12Kompressor confirmation

Hopefully these item below RM1, then it is possible to make it RM20 sharp

C2KBAS2005

Iswaga also can add, but not sure is there significant improvement compare to poor Campor engine. Besides, Iswaga Mitshi engine conductivity quite good already, engine hook is otherside of distributor cap(unlike Campor independance firing system), I supposed it need different mounting point in order to benefit from it

NewbieBetta

It is advisable to remove all those mods before send for SC service. Don't forget the grounding work involved ENGINE HOOK, they can easily call it OWN DAMAGE & void your engine/electrical/battery/ECU/CVT warranty. Mod is mod, if really things make you worried, you shd avoid at all cost just for the peace of mind

This is NOT a test on BLM



This is tested on a BLM

Insurance Info




More to read


So, insuflex also can cause you void INSURANCE, not to mention warranty. Not even that, it may void your life insurance also, because you breathe in CA glue that might cause lungs cancer depends on how you deal with SC only. If dai dai wanna go claim still dun wanto take off wadeberdapuk inside your car that might jeopardize your claim(be it warranty or insurance claim), who you gonna blame Already told NewbieBetta, if too worried on those, might as well don't do anything to the car. Btw, did I ever told you I work in 1 of the largest motor insurance company in Boleyland?

Just went to magician to confirmed the big arse ground cable. Some sohigh conclusion made me wonder what happened to today's technology

1) Rocker cover is bad in conductivity. Either made of cast iron or ceremic Which means those grounding kit that connect spaghetti has very little effect if connected to the rocker cover. Go & pop ur hood & see, all bolts on rocker cover are screwed on a metal casing, & the metal casing was melted on the low conductive rocker cover So tell me, what you wanna ground?

2) Since its independance firing system, each cylinder has their own +ve & -ve currentflow, which draw/direct power flow to/from fuse box. Take note this is NOT design flaw, its the nature of independance firing system. To avoid static being channel to the sound system(aeroplane sound). Your individual firing coil should fully functional even without grounding kit. The only speculation for grounding kit to improve performance in this case will be, instead of 4 coil send back -ve flow via 4 small lane, we open a huge arse hiway for them to go back 1 shot, so to shorten electron flow(according to coolkwc lecture)

I asked, why in the hell Plotong does not include this in the design. Answered from magician was, cost cutting. Whatever aftermarket mod we do to improve our car was a huge cost to manufacturer. Several things Plotong concern:

1) The R&D on these small matter would cost million dollars. So happened sohigh YAB accidentally clamp the jump start cable on the sweet spot.

2) Improve performance would yield different PPM reading, need to redesign catcon just to stay ahead of polution standard. Again would incur extra million of development cost.

3) This kinda improvement was NOT meant for manufacturer. As a principle, their product expectation are granted as standard product. So, whatever IMPROVEMENT is not standard. They gave us 94hp, & that's all we should expect from them. If you bought a PERVE IAFM, will u ask why not plonk a turbo? Simple, bcoz the car u bought is not a CFE version.

Current costing stands at RM19.40 with bolt & nut for mounting point, assemble by Bangala. Pending 1 last step from V12k on the shrink wrap & we shall start bulk

Can FLX user confirm me whether your engine has the hook?

Warranty void bcoz use OBD reader

If u no use OBD how u know throttle 14.9%

U sure u no use OBD reader? Lemme use PDT check first. No ar, our PDT say your throttle position normal. No need to fix

Cainis Niu Yier Bulk Effort
Improve Campor IAFM throttle lag



Ground cable made of 300amps copper core welding cable

Some vehicle have this effect:


Helps reduced light dim when AC kicks in
Some said they have a problem when AC kicks in, light will dim
I didn't notice that problem, but it seems fine to me


More importantly I find it useful on this improvement
Standard machine, throttle lag by seconds

I find some obvious reduction, especially AC kicks in has greatly reduces power loss


T&C
RM20/unit for local self collect ONLY
Sorry currently not available for shipping
Complete product
Minimum order 10 units
Order close date 10th February, 2013
Payment in advance to avoid FFK disappointment
Please bank in latest by 14th February, 2013
Collection date after 18th February, 2013

Banking detail


Bulk list as below:

1. kenjilew
2. mahihi
3. SiuYi
4. SiuYi
5. C2KBAS2005
6. C2KBAS2005

Please fill up the list if you're interested. Kindly add [ * ] without spacing infront of your name.

Disclaimer: These sohighness effects could all be placebo as I have no proof nor data to support it. I've discovered this all because of a stupid accident, and I like the feeling. I thought I wanna share this affordable add on for the rest of budget modder and placebo worshiper. If you find no improvement in your car after install this thing please don't blame me. Placebo are subjective, my butt is different than your butt, so you have all the rights to complain you don't feel shit that I felt. Anyway, grounding cable will not do harm to your car unless you short circuit it with POSITIVE energy. So, having the cable in your engine bay will only make things better and no harm done after all(again, unless you short circuit it). Do remember I'm not responsible for any damages caused(if any lar, ground cable yo), use at your own risk.

This post has been edited by davidke20: Feb 6 2013, 08:04 PM

I cant promise yet, for the time being. Busy RAYA