Does APES sell these?

thanks

i think so. just do a search in the full systems sub-forum in garage sale for other buyers. i tell you what tho, if ur not planning on sleeving ur molex cables, better to go buy tailor style pins from stationary shop for rm1.30.

i've tried both the tool sets, lamptron, sunbeamtech vailable on the forum, and in the end i only needed to use the molex removal tool in the set. for the atx 20+4 and 8/4 pin the tools were annoying to use and pretty useless. using the pins was cheap and easier to use.

Soon I will write a guide on how to make a getto pin remover tool, super cheap & easy if you got powertools. otherwise grinding it manually with hand will take hours though...

once I get the time of course...quite busy researching on stuff for now haha...just check my worklog or blog once its updated but yeah although its easy to create for normal atx pins, its not that easy for molex...havent find a solution for this yet & also for those fan wires...

it'll be interesting to see a DIY version of the remover tools.

for molex 4pins should be easy enough. just need to find the right diameter tubes. atx, eps and 6 pin might be trickier coz need prong removal tool.

fan pin easiest. just go get a slim tweezer and poke. heck, screwdriver, sewing needle, pin also can!

i tried but it just wont come out...not sure if I am doing it wrong or what... maybe I should try poking harder & pulling out with more force...

infernoaswen for the fan header? push the wire in a little, push down the pin and pull the wire straight out.

ya...if I am not mistaken I tried that...but will try again once I get my casing