thanks..it works, i've managed to establish internet with e398, however, i'm connecting through WAN interface instead of 3g interface, is this correct.
and my device behind this router cannot ping like google.com and the rest.. firewall setting issue?
The long awaited MR3420V2 firmware is now available for download.
And the preliminary version of BlackWidow is also available.
This can be flashed while keeping your old config files since there are only changes to a few scripts.
BlackWidow has a better modem detection scheme that uses the attached drivers to determine which protocol to use. "No more specific support for individual modems except for a few oddballs", to steal a quote from Billion.
If you have a E392 or E3276 then this is the firmware for you.
It has been tested with the Sierra 320U for Direct IP, the MF668 for QMI and various modems for PPP. All are detected correctly so the NCM detection should also work.
does this new firmware support huawei e398? can we flash direct from the openwrt firmware available from 1st page? seem like blackwidow is tester firmware, many thanks
This post has been edited by garytey: Mar 13 2013, 05:26 PM
Yes. The modem list is here. This is the link to the new BlackWidow firmware. Simply flash an existing Spider ROOTer and keep the configuration scripts. It is essentially a beta release, to overcome serious deficiencies in the modem detection scripts in Redback.
It may have bugs as the method of modem recognition has been altered. It has already been tested on a limited set of modems.
The new MR3420 V2 ROOTer works fine.
Over to you guys to test and play.
Cheers
John k
hi, can you add also the original router firmware for MR3420 V2 also
guys, out of topic, i need a higher grade usb modem router, able to perform multiwan(load balance), routing for hosting etc and most importantly must be reliable, for 50 to 100 user working environment, any expert here can advise? microtik?
Feb 21 2013, 05:35 PM
Quote
0.0485sec
0.55
7 queries
GZIP Disabled