how bout other setting? jumper?
try borrow psu from ur friend and test it...
p4p800-x cold boot problem
|
|
 Mar 20 2006, 01:12 AM
Return to original view | Post
#1
|
 
Senior Member
836 posts Joined: Sep 2004 From: CyBerJaYa  
|
|
Quote|
|
|
|
|
Mar 22 2006, 12:23 AM
Return to original view | Post
#2
|
|
Senior Member
836 posts Joined: Sep 2004 From: CyBerJaYa
|
QUOTE(AREA51 @ Mar 21 2006, 09:26 PM) hey thanks for replying... change ur psu...unfortunately all my friends are using worse PSU than what i have. Basically i have a celeron D 2.4@3.6 E0 stepping not prime stable unless i up the voltage to 1.475v (i know many E0 cel D does 3.6 at stock voltage, could it be my PSU?). At this voltage everything runs fine... but when i try to restart the com it wont start. A cold boot wouldnt happen either..   previously i also using celeron d 2.4ghz, running fine at 3.6ghz @ default vcore.. there is a case where i use icute 450w psu, highest i can go @ default vcore is 200mhz when i change to CM real power, i can go 211mhz... |
|
|
Mar 24 2006, 05:01 PM
Return to original view | Post
#3
|
|
Senior Member
836 posts Joined: Sep 2004 From: CyBerJaYa
|
QUOTE(fridaynite @ Mar 24 2006, 12:07 AM) borrow thread how bout mem divider? I got a similar setup celeron d 2.4G and p4p800 dlx. my celly is running at 3.15G default voltage (175 mhz, DDR350). I can't get it above that no matter what voltage i pump in. what's the problem? someone plz help..  |
|
|
Mar 24 2006, 07:45 PM
Return to original view | Post
#4
|
|
Senior Member
836 posts Joined: Sep 2004 From: CyBerJaYa
|
QUOTE(fridaynite @ Mar 24 2006, 07:34 PM) it's actually 1:1 already - RAM at DDR350 only mind list out ur spec? |
|
|
Mar 24 2006, 10:40 PM
Return to original view | Post
#5
|
|
Senior Member
836 posts Joined: Sep 2004 From: CyBerJaYa
|
QUOTE(fridaynite @ Mar 24 2006, 07:56 PM) pretty basic how much u give for vdimm? i only know p4p800 deluxe got 2.85v...try set to the max...Celeron D 320 (2.4Ghz) Asus P4P800 Deluxe 2x512MB Twinmos SP (UTT CH-5) - does 2-2-2-11@240Mhz@3.3V on my old nf2 board Antec 480W SLK947U + 92mm Delta abd did u lock the pci/agp bus? |
| Change to: |  0.0158sec
 1.36
 6 queries
 GZIP Disabled
Time is now: 30th November 2025 - 03:32 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.