all sifus plz help
Steps to set 4v vdimm for DFI NF4 ultra-d
|
|
 Mar 18 2006, 03:56 PM, updated 20y ago
Return to original view | Post
#1
|
 
Senior Member
1,561 posts Joined: Jan 2003 From: 秋葉原電気街  
|
hello... i m gonna get a pair of mushkin bh5 from kcync soon.... before this i would like to know other then set the jumper on the board to 4v is there any other thing that i need to do??? like reset bios and stuff???
all sifus plz help |
Quote|
|
|
|
|
Mar 18 2006, 06:54 PM
Return to original view | Post
#2
|
|
Senior Member
1,561 posts Joined: Jan 2003 From: 秋葉原電気街
|
ah ok.... i tot of that also...but babyelf told me b4...need to reset bios n stuff...so i m kinda confuse now...
|
|
|
Mar 19 2006, 10:32 AM
Return to original view | Post
#3
|
|
Senior Member
1,561 posts Joined: Jan 2003 From: 秋葉原電気街
|
nono....not too extreme....just that the voltage hunger bh5 need more than 3.2v only...initial plan now is 3.4 @ 250 2-2-2-5 or higher clock at 3.5v.... anyway thanks for all the guide guys.... will try it when my ram is here
 This post has been edited by sup3rfly: Mar 19 2006, 10:33 AM |
|
|
Mar 19 2006, 03:49 PM
Return to original view | Post
#4
|
|
Senior Member
1,561 posts Joined: Jan 2003 From: 秋葉原電気街
|
QUOTE(tAmp0i @ Mar 19 2006, 02:41 PM) Remember to set Vdimm to < 3.2v before positioning back the jumper to 3.2v location or bad luck will happen u mean if i wan to use less than 3.2v must change back to <3.2v then only change jumper right???  |
| Change to: |  0.0138sec
 0.79
 6 queries
 GZIP Disabled
Time is now: 2nd December 2025 - 01:55 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.