hello... i m gonna get a pair of mushkin bh5 from kcync soon.... before this i would like to know other then set the jumper on the board to 4v is there any other thing that i need to do??? like reset bios and stuff???

all sifus plz help

i just set it 2 das ago...
just read the manual to set the jumper and u'll get 4v vdimm...

read d manual... all steps are provided there if i'm not mistaken...

This post has been edited by ah_khoo: Mar 18 2006, 05:37 PM

IIRC, set your Startup VID and CPU voltage, leave them no AUTO and then power off. Move your jumper and boot again. There you have the 4vdimm.

I have set the jumper for the 4Vdimm last time for my Twinmoss BH-5.I just follow whatever writen in the manual and finnaly I can set the Vdimm up to 4V.

ah ok.... i tot of that also...but babyelf told me b4...need to reset bios n stuff...so i m kinda confuse now...

just move the jumper to the other way(find it in the manual). then do not set the vcore & vdimm to auto. then u got 4v vdimm option coming up..

just make sure you set the BIOS VDIMM to 2.8V first, before you change the jumper.....

just to be safe

goin' 4 extreme OC ya? gud luck then.. & dont forget to post ur archivement

nono....not too extreme....just that the voltage hunger bh5 need more than 3.2v only...initial plan now is 3.4 @ 250 2-2-2-5 or higher clock at 3.5v.... anyway thanks for all the guide guys.... will try it when my ram is here

This post has been edited by sup3rfly: Mar 19 2006, 10:33 AM

Remember to set Vdimm to < 3.2v before positioning back the jumper to 3.2v location or bad luck will happen

u mean if i wan to use less than 3.2v must change back to <3.2v then only change jumper right???

//OFFTOPIC

sorry for tumpang ur thread..

izzit DFI NF4 Ultra Infinity also can sapot 4v vdimm?

This post has been edited by kulus: Mar 19 2006, 04:33 PM

iirc this has something to do with the heat in mosfet area
if you want to changhe the jumper back to the initial position (<3.2v vdimm) make sure to reset cmos
please cmiiw

nope, max of 3.2v

owh... so except dfi..wut mobo can give voltage more than 3.2 v?

aiyaaa..need a lot of juice to feed BH-5 ram

Yupe, that's it Set the Vdimm to < 3.2v before changing the jumper....