i using moshi hard case...
no problem on my phone...
however, last week i visit to lowyat plaza to look for casing,
i notice that those cheap casing has very sharp edge that could scratch your iphone...
i compare to my moshi of cos cost me RM130 for original, the edge is very smooth...
thus my advise....alway go for high quality if you using hard casing.

Bear in mind that any soft jacket will have such issue too as since materials of case are stretchable..

Dust and miscelleneuos will be entering your device from the holes of case and worst still as you don't clean it constantly.. Scratchess everywhere without intention

Got dent or bent?

This is true, need to constantly clean it from dust, to prevent those small scracthes

Really not impressed with the build quality for this gen.

Yea some thoughts of sharing
As many may mislead that thought of jelly cases will be harmless

Until sumone invented a vacuum sealed casing, u will still need to remove the casing every now n then to clean it from dust and other tiny particles that can trap in between the cover n the phone, if not those trapped dusts will eventually scratch ur phone im afraid..

I coated my whole phone with Liquipel! Scratch and water proof!

hm...will the bumper case more prompt for dust to enter the case and scratch up the side of the phone?

Otterbox commuter series..soft inner and hard outer..WIN!

Anyone using the SGP bumper rm125 one?
They got give back SP some more.

me using one

is it good? do u recommend me to buy?

cuz i read online review says that the outer shield will slip off one.

Need to sent in for "liquided" every 3-4 months and depend on usage ,not permanent solution.

Where do you go to " re-liquefy ", how much does it cost each time and how long is the process each time？

i'm not using coz my supplier told me

The rule of thumb, go for super tight one, loose one tend to collect dust and scratch your iphone(I can never forget swircheasy nude that scratched my ipad,same concept apply here). Before install, please blow away all the dust, also do not uninstall and install all the time to look at the beauty of the back, you never know a small sand creep in without your notice.

This post has been edited by airbag_grado: Jan 6 2013, 04:05 PM

Buy the transparent sticker. Trim it to the width of the shinny bezel. Paste it over. Ensure all surface are covered. Then put it into your soft case. Hassle free.

Recommended but metal slate or gun metal nice

does machines in mid valley and sunway pyramid sells it?

i only found that in the apple retaillers Publika. but that's too far for me to go again.