Where got rubber seal? U kena trolled already.

his one is different

His PE? Ya, veli different.

really??

at bandar baru bangi now working...

Haha..agreed..this rubber seal and sound proof material is different thing

I am currently working in Seremban for a few days but over the weekends I will be around Klang Valley. So if there are any reasonable tyre shops in Seremban, I wouldn't mind buying new tyres here.

2 of my tyres are blackbird another 2 are goodyear. I'm planning to replace the goodyears cos it has a crack in it.

The newton would be the NT8000 I assume? Yes, I agree. I'm holding back on getting the Michelin cos of its price.

such a pain

http://ondscene.my/kemalangan/treler-penga...ereta-tercampak

Yesterday went through water for the 1st time. Luckily didn't stall engine

how deep is the water?

normally if keep constant throttle then wont stall one...

unless water submerge till windscreen.

my first was above fog lamps... lucky no water enter through the door

You were at Sungai Long right? Always flood one this area once it's heavy rain.
I think exceed quarter of my tires. I know the technique is to accelerate & don't decelerate right?

---

Added on November 28, 2012, 1:40 pmSame. I think "ngam ngam" didn't enter through door.

This post has been edited by kennywee92: Nov 28 2012, 01:40 PM

The owner of the car must be very sad

oo, i always escape that area using higher ground de road one, like the road in front of UTAR. Furthermore if really flood, i just swap car with my friend and drive his CRV home.

yes, just accelerate and never stop. lol

worse is the unlucky owner doesn't know their car been in accident before...

I think I'm gonna lepak in Sungai Long until rain stops if it rains heavily again

BULK FOR PERSONA CABIN FILTER (PATCO/SANDEN). Closing at 30th November 2012

Price : 3 pcs : RM12, 6 pcs : RM10.50, >10 pcs : RM 9.50 per pc. If demand a lot more, maybe can ask for cheaper price.
Poslaju charges : RM6 for P. Msia.
State name, quantity and type.

Patco
Sanden

Namelist

1) Fubar20 - 2 pcs (Patco)
2) Shelby - 2 pcs (Patco)
3) jasonloh7906 - 2 pcs (Sanden)
4) Ckdenion - 1 pc (Patco/Sanden)
5) kennywee92 - 2 pcs (Patco)
6) solarwing - 1 pc (Patco)
7) Josh_M - 1 pc (Sanden)
8) Nemesis813 - 3 pcs (Sanden)
9) TheFQ400 - 2 pcs (Sanden)
10) Baozzz - 2 pcs (Sanden)
11) s7ran9er - 2 pcs (Sanden)
12)
13)
14)
15)

Very bad luck if like that.

RS is considered cheap for its performance. Only the noise is making me wanted to change.
but wanted to make it wear down seems to be a very hard job.

I don't think the rubberseal is perfect, in fact i think it don't work that nice on persona. in fact my gaga dont have any rubberseal on it.

mine also got no significant noise reduction. i think you just need to feel in the gap that will have wind go through.

no comment. never really wanted to go for 30. i am most of the time at high speed rather than stucking in a jam.
This also makes me think whether i should change my 4-2-1 to 4-1.

haha, ask those ppl here. i dunno where they previously change the tyre. and apa blackbird is that

make sure you rev it then it wont stall.

mine enter through my leg
then only i check and realised got very very small hole that connect something to the engine compartment. so the water pressure force water into the car when i bang over it i suppose.

can flood the cabin if this repetitively happen?

neuton nt8000 poison :

neuton