yea
if 1 people say it's bad then it might be biased
but all people say they're bad
means sure got something inside them

cheers

ya.....i dun really know bout their services, cos nv done there before....
but i check out their amps before.....erm, ahem, ahem, haha, u know wat i mean la.....

well, myvi speaker really lame la, sound so soft....
and i tot it was blaupunkt player but it was only clarion........

clarion not bad mah
its juz the player make for Perodua is not so good nia
Perodua need to cut cost too

my myvi 1.0 ice:

-added audio quart component set( rear door put 6"mid and tweeter put at front) results:very clear sound produced
-jus bought 10" mohawk subwoofer (will use my old epsilon amp to power it up) gonna install it on monday hehehhe....cant wait...

Clarion is good stuff, but dunno bout OEM lah, maybe they custom made budget versions for Perodua. Anyway, I saw a leaflet from Brothers' , they already start selling the audio bracket for MyVi, that means, you can take away the awful HU, put in your new HU, put the bracket (actually a dashboard cover, if you know what i mean) and your car won't look like a dork anymore.

RM1k can get you very decent audio, if you don't change the HU. My conservative setup of 1x10" DVC ~300w RMS 2nd hand woofer, custom made deep enclosure (to compensate the fact it's a 10" woofer), a 2nd hand 4 channel Alpine 85wRMSx4 amp, workmanship, is already costing RM500+, not including the cable.(someone sponsored me their cable, else, add RM100) and you really need a nice component set to complement your bass, trust me. ADD RM250 for a no-namer 100wRMS (make sure it's true) . Add RM600 for a decent HU and your budget goes down the drain. So don't simply change the HU unless you really got more budget.

http://forum.myviclub.com/index.php?act=ST...=270#entry66757

check out my myvi pics....i had used up rm700 for my set fully satisfied....(700 nt include amp)

1 thing i think seriously needed is a preamp because it really helps a lot to tune the high/mid/bass/mid bass which is very important...if nt no matter what setup u hav also sux ....my oppinion only la...haha...

a preamp can't really tune/effect much in the effect
an electronic will be better
but everything is limit by the passives

may i know how much you bought the 10" mohawk sub with box?

Just wana ask, Myvi rear door can fit in 6.5inch or not? What is the original speaker size for the rear door? (Did you cus a hole in your rear door too?)

can
now got a new add-on speaker panel for Myvi
no need to cut the door panel
selling for RM2xx IIRC

tumpang thread a while...

hi guys,

just got my new avanza, the stock sound system sarks i'd say...or maybe it's due to the nice speakers i had in my altis...need some recommendations from u guys on how to fix up the sound system in the avanza...

any suggestions?

from what i know,

1- clarion is better than blaupunkt (i know this coz i've changed mine from gen2 stock HU to clarion) . even stock clarion is better than blaupunkt if u have good wiring and speakers.

2- just put 2-channel amp and 2X10" woofer is enough. but u must have good wiring system and crossover. let the HU to control stock speakers. later on if u wanna upgrade, u can put another 2-channel amp just for the speakers. it will boost the power of mid and treble. but make sure u don't just mix the component. or else the sound will be awfully terrible.

3- for lower budget, i suggest u to change the HU and get 6X9 three-way speakers at the back. no need to put subwoofer. add tweeter at the front. that's enough for budget lower than RM1k.

sorry if i'm wrong. my opinion is based on experience and info from others.

This post has been edited by kardock: Jul 4 2006, 04:08 AM

Stock HU almost the same la...cheap & low quality.
Because they produce a lot quantity for car manufacturer with cheap price.

o yeah...

for those who wanna put the 6x9 speakers @ the back.. plz PM me.. i can change wif 'em.. meaning.. no need 2 make holes for the 6x9 cz mine aledi have the holes for the speakers..

hmm.. try 2 start wif good component speakers wif good mid bass.. eg. alpine type-R?...
then an amplifier(3/5 channels)...
after tat HU...
last and not least add a woofer... (1x10" o 1x12" in a 1.25-1.5 cu/f2 sealed box)

RM400???

http://www.lelong.com.my/Auc/List/2007-12D...W_SUBWOOFER.htm