no Ultra-D / SLI-D/DR version?...

impressize....very impressive...

calling for @allngap....if u making this one with all ur acrylic toyz...sure boom!!

hey..how much that freakin' stuff..? might be interested..hehe

Almost all the motherboard which has the DDR and mosfets located at around the same place can use this fan mount. The mounting holes are the same since all of the are ATX boards.


From his first guess, he said that the manufacturers will cut it on their laser cutter for USD2.25/min. So I guess it takes about 5 - 7 mins to cut one piece. About $11 - $15 + shipping? It will include all necessary screws for the installation.

This post has been edited by kcnyc: Jan 22 2006, 02:53 AM

that is not a problem at all. just afraid that the vibrations from the fans would resonate only

but the mounts are really expensive....

the master is here.. wif some comment

good concept..but i think should've made it with bigger fans.. 2 40mm fans won't do much for the memory..

80mm?92mm?
i've seen the same consept done by my friend(custom made)with 80mm led fan.

This post has been edited by kingmaker_20: Jan 22 2006, 11:26 AM

i'm thinking low profile 120mm.. but i'm trying to design something that will hold the full 120mm fans.. already have a rough design for the low profile ones..

why not use atholon xp stock fans ??

i think this can be the solution? you can ezly found when you got your casing..

i m gonna get a piece acrylic ansd try this...gonan use 2x 6cm fan

If you guys use a 60mm or 120mm fan, you will be eating the space of the heatsink. The designer of this thingy made this so that big heatsink, waterblocks and even phase change evaporators are able to be put on with the mount already mounted on the board. Think about that before jumping to bigger fans.

i m using si-120..there is some free space in the middle...so i might just take some of it space lo
i dunno just a try.....not good then nvm...take it out hehehe

As long as you have space for the heatsink and fan then should be ok. I just wanted to remind you guys about the heatsink space.

i did this using dual delta 60mm on the rams for gsan, with clip on design on the ram slots


the idea is not only limited to 40mm fans, blowers can be utilised as well.

This post has been edited by AllnGap: Jan 22 2006, 04:13 PM

Any other pics?maybe side view.

How about putting spans or rubber (high quality ones ar) at the mounting screws?
Like the one used for hyper6+,and some GC hsf. That will lessen the vibration.
Or even better sockets+spans like the CPU socket but that's going to be costly.

I'm interested if ur making 1 allngap

This post has been edited by DaBaD: Jan 28 2006, 09:15 AM

now this is wat i'm looking for. someone pls mass-produce this

It's on the way bro.....lol.

really, whos' doing it??