if me ar... if i start from 0 again, i might want to try front upper and lower then 19mm ARB

i think i can skip the rear upper and lower bars...

yes bro

sorry ar, i forgot how much... its cheaper than the ARB for sure
you can check with Nazlee from Kaitenaz Racing (Sunway), tell him kenji recommended

Vios have a hollow 23mm front ARB, the UR one is solid, i read that its difficult to install...

different purpose... ARB are more for car "twisting" during cornering, can adjust the understeer/oversteer depending one the thickness of the front and rear ARB combo
other bars are more to chassis enhancement, making the chassis more solid

ohh... then you might need to check with the local shops around your area...
if its significantly cheaper in KL, can order then just give your local workshop installation fees

Ya, it is normal. It happens on every toyota car equiped with abs

Just put on stiff ring on my Vios (2009). First thing I noticed, the car and steering is more solid instead of the "lose" feeling and noticeably quieter on uneven road.

Just put on stiff ring on my Vios (2009). First thing I noticed, the car and steering is more solid instead of the "lose" feeling and noticeably quieter on uneven road.

if I open car boot use the driver seat switch, then the boot will not able to close, the lock was jam. if I use the switch from key then it ok. may I know how can I fix it without cost a lot. no more warranty at sc. because no going back for service.

both design is same material is same different is braking system.

Hi guys,

I'm vios07 owner, S type to be exact since 2008.
I do have question for all sifu's, my autolock not function as normal as previous condition. Not even after reach 20km/h, except manual lock.
Can any sifu's advice any solution.

Hi guys, any of you know the place to install fog lamp in Klang Valley area?
Mine is a J-spec, so if install would they cut wire and hence void the warranty??

Thank you for your kind information.

yea, i know it's plug and play for e-spec and above. but J spec do not have any wiring and push button around the dashboard. so a lot of addition wiring work has to be done.

correct me if i'm wrong.

thanks!

what millage is ur car nw when encouter tis problem?

my car gt same sound like u when less than 1k, now 13k+ also got tis sound but less...

last time due to sound tak tak all the way til i tak tahan, i jus walk in and the mechanic test drive with me, and told me sound is on the door panel, need to open and c what problem.

after when for 10k service, they told me sound is from dashboard, they jus fix the dashboard, the sound had reduce but somehow it do happen but no as noisy as be4.

I also happened to face noise coming from the front side passenger drawer there whenever moves through un-even road, guess what...the root cause of the noise is due to the lid of the drawer itself, after closing the drawer, there is still a gap between the drawer lid and the dashboard, so when car moves over uneven road surface, the drawer lid will vibrates and keep knocking thus produces the noise, solution is to place something heavy in the drawer so that the drawer lid won't vibrate, or paste some rubber tapes around the edge of the drawer lid to stop the noise.
After all, nowadays Toyota cars fit and finish is not really good already I would say. But this car is still nice to drive.

Anyone here knows how to replace gear panel bulb? I wanna change to LED, please share your experience.. Thanks

thanks anyway I already disassemble them few days ago when I was free, I already know how to remove the bulbs..
for your reference, bulbs used at AC panel are a total of 3 x T4.2 (Japanese called them these) while gear panel bulb is T5

feel free to! PM me if you need help, I shall provide you my whatsapp and share some pics

Bro done u DIY project? pls upload here to share with us thanks