Btw just a note

before you go bang wall and buy a unit there, you'll be having shitty internet speeds because the prop dev decided to go full retard


and check your electricity supply splitters as well

each unit is equipped with 2 ACs as well as a shower heater

the kitchen cab and sink very gooding also :v

This post has been edited by overl33t: Oct 9 2015, 07:43 PM

There is
But the connectors used in the MATV Risers and FWS are not the ones you're suppoaed to be using for this kind of application.

Normally those connectors are connected to your modem instead of the riser or MDF but since they're cheap, the prop dev decided to use them so in the end they end up degrading after a few days, resulting in high data loss, sometimes even no connection

So before you start blaming your ISP, you might want to have a look at those first because we already advise the property dev to no avail already

Not sure about the other units though

This post has been edited by overl33t: Oct 10 2015, 10:48 AM

We test for data loss between the riser(located next to the electric supply riser) and the respective units.

The data loss that comes out is based on LAN environment so we normally have to improvise to keep it very low because internet speed is typically at 30-40% of speeds achieved in LAN environment

Just to confirm, KR2 is the unit located in front of Awan Nesar LRT STATION AND YL COMPLEX RIGHT?

This post has been edited by overl33t: Oct 10 2015, 11:02 AM

Simple explanation: you're not supposed to use the connectors being used in KR2 to connect the units to the room where everything is connected to the service providers

lmao confidential dy that one

but suffice to say that the data loss rate is higher than contracted rate because of this

if you want you can come over to KR2 and have a look at the facilities urself. i heard they plan to hand over the keys soon

won't say anymore from here on out. later boss find out then i hailat jor

This post has been edited by overl33t: Oct 12 2015, 08:27 AM