last month i do allignment and balancing for my car..found my rear tyre allignment out of range too much..foreman put some ring to make it in range..he say some part hv problem already,but he din mention properly...izit is dog bone?any sifu here know what part will cause allignment out of range too much?pls let me know as i wish to change that part and redo my allignment..thanks..

This post has been edited by shen1716: Jul 27 2012, 10:28 PM

gear inside TB kong..just replace it will do..cost less than rm100..last time i change is rm80.

How about if change to wira 1.6 absorber which are stiffer?so tat car wont be lowered too much when carry too much..

wira 1.5 can use those smaller oil filter which using by wira 1.6?some said smaller oil filter give better oil flow thus make engine warm up faster and better performance..izit true?

1.5 and 1.6 using different series of engine...4g15 and 4g92..that's why they hv big different in terms of performance..

u can go to those workshop that hv PDT to check the error code..normally is O2 sensor kong..

my wira 1.5 have dashboard rattling noise when going uneven road?anyone know what's the problem?

will change my manual gear oil soon...castrol or toyota oil more suitable and better?

Try getting wira 1.5 auto which is year 2000 and above due to fuel injection.carb version wira are not fuel efficient as fuel injection.wira 1.6 auto might hv better fc,but t hv problematic gearbox.

Sry,my previous reply is to reply garyccw.

hi,my wira produce woo woo sound when turn right,but turn left is ok.izit is drive shaft problem?