Very good ideal if it does work, instead of paying rm200 to TM contractor, use the money for a pair of homeplug.

Homeplug is around rm160, non standard installation sure kena rm150 and up.
But avantage of homeplug is you can move the router any where you like in the house. (provided that it works)

Anyway, you better be sure, you dont want to end up the indoor fiber cable is cut too short and the homeplug option doesnt work.

The best is to pull the indoor fiber cable as far as standard installation allow and instal the router there. Only then you think about the homeplug option to move the router.

To TS and second post poster, please post below Aztech E310-S user manual link to the 1st or 2nd post before it got buried by incoming posts.

ftp://ftp.aztech.com/support/SINGAPORE/DE...nual%20v1.1.pdf

If you stream youtube, you would not notice it because the speed is fast enough to buffer the 20 to 30 seconds downtime. Also if you are reading a stationary web page, you don't feel it too. But if you jump from pages to pages, you will notice the short DC.
I have plenty of "xDSL linestate down" in my log too, sometimes when I click on LYN thread link from another page, my firefox browser occasionally needs more than 10 sec to load up the page, sometime I have to refresh the loading. However in most instances, the browser can load a LYN page instantly within half second.

Very common, it had been discussed at lenght in this thread. Browser keep loading a page. Spmetimes got to stop the loading and click refresh only then the page load up.

Damn, i thought maxis automatically alloted the free 150 minutes to my maxis mobile already.
As the matter of fact, no free minutes alloted to my maxis mobile account yet. I need to call them, ask them and the CS replied " i need to check with the Home department first".

I called CS yesterday, just now received call from CS that my 150min now assigned to my Maxis mobile effective today.
If based on market average call rate of 10sen per min for on-net calls, the 600+150 free minutes is valued at Rm75 already.
If you are not a maxis mobile user, based on the average off-net call rate of 15sen/min, the 600 free minutes is worth Rm90 to you.

Thats usage limit. Not related. Call 123 to check your free minutes assignment.

Once a while, I'm getting this speed over Wifi network (any MHF user here can better this ? ).
However. while DL speed test, the meter needle was only hovers around 2 to 3 Mbps range for the 1st half of DL test process and then a sudden burst/spike of speed at the end. (Observe the yellow circle)

10 out of 10 tests, the speed test demonstrated the above behavior, spike of speed towards the end. Anyone can explain this ?

 I have bunch of these. Landed house.


Jul 14 23:27:04 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:42:27 xDSL linestate down


  Jul 14 23:40:38 xDSL linestate down


  Jul 14 23:40:16 xDSL linestate down


  Jul 14 23:37:54 xDSL linestate down


  Jul 14 23:10:12 xDSL linestate down


  Jul 14 23:09:50 xDSL linestate down


  Jul 14 23:01:29 xDSL linestate down


  Jul 14 23:00:30 xDSL linestate down

---

Added on July 14, 2012, 11:50 pm  Jul 14 23:27:04 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:25:10 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:24:09 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:22:39 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:17:35 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:16:12 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:14:51 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:13:28 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:12:13 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


  Jul 14 23:10:00 LOGIN wireless station [6c:23:b9:84:f7:e7] can't get authorized.


This post has been edited by aeiou228: Jul 14 2012, 11:50 PM

How to access ONT ?
SNR is the reading tm installer took during instalation ? My area i guess not many yet.

Before you buy the expensive homeplug, you may want to consider this alternative solution with zero cost.
I solved the weak wifi signal problem with my redundant wifi router Linksys WRT54G previously used for Streamyx.
I just changed the Wireless setting of Linksys to AP mode and plug it LAN to LAN to Thomson.
Now I have 2 SSIDs, one from Linksys (stronger) and another from Thomson (weaker).
Speed test done indicated no different in speed and latency.
Thomson router performance dropped when too many wifi devices logged in at the same time so I hope Linksys can share the load and solve this problem too.


If want full signal even 2 houses away, buy this high gained USB Wifi adapter (if you are using PC or laptop).
I got one extra unit (in sealed box) to let go for RM50.

There is no such waiting time, mine worked on the spot.
The 24 hours wait was a lie to deceive you to sign the job sheet so that he can cabut and leave the problem to you and Maxis.

This post has been edited by aeiou228: Jul 17 2012, 11:21 AM

If you sign the job sheet, you set them free and the responsibility is therefore transfer to you to follow up the blunder.

This post has been edited by aeiou228: Jul 17 2012, 11:32 AM

But my voip was working yesterday and this morning.

Went to maxis center to change my VoIP number, selected the only triple digit number left in the list. 03-A888BCCC.
The maxis guy wanted to charge me RM25 for the change but I told him 1st change is free then he checked something on his screen and said "ok, free."

To those who are interested to know the power consumption of TM modem and Thomson router.

TM modem 4.4w
Thomson router 8.8w (total 13.2w)
Aztech Dect phone 0.5w (total 13.7w)
Laptop cooler 2.8w (total 16.5w)
Total annual electricity consumption in kw/h: 16.5w x 24hr x 365days / 1000 =144,540
Total TNB bill based on 33.4 sen per unit catergory is: RM48.28
Total TNB bill based on 40 sen per unit catergory is: RM57.82

Can change the last 4 or 3 digit only. Go fast fast change, all nice numbers almost taken liao. I lucky today still got one triple digit left.

I still get the two messages. With or without the cooler, the perfomance is the same with occasional unresponsive page loading.

Actually "CAN". I've "done" that.
All Unifi and MHF agent has ready answer for this most frequently asked question "Can I retain my existing TM number ?"

Instead of saying "CAN NOT", they TWISTED THE WORDS and say "Can retain but need to pay RM26". Sounds better to lure you to signup immediately right ?

Only if you ask him further "RM26 is one time payment ?" Then he will tell you that you need to pay RM26 every month. Yet he still doesn't reveal to you that you are actually keeping you existing TM line with the standard monthly rental of RM26.

I still haven't cancel my TM home line, that's why I said "CAN RETAIN".