huawei got cat 6 gadgets now

pairing with xiaomi powerbank 10400mAh

This post has been edited by coolstore: May 26 2014, 01:57 PM

you mean YES's LTE broadband? not launching yet, same 2600MHz but it is LTE-TDD, not LTE-FDD used by maxis/celcom/umobile/digi etc. both P1 (TM owned now) and YES LTE will be based on TDD (unless they change their mind, who knows)

if your 4g modem support both FDD and TDD, then can use any 1 of them in future, easily change ISP if not satisfied.

-22 seems best suit malaysia (support both FDD & TDD 2600MHz)

so they are going ask oem huawei / zte or korea manufacturer to make them proprietary modem again?

erm, TM seems not likely doing this way after take over P1 to tap into wireless market, they wanted roll out asap and being cost effective to make P1 profitable and contribute to TM group financial performance. they should use sim card base and existing LTE modem products without surprise.

if such happenings, leaving Yes on island mode again ...

huawei quality is better, hence also more expensive.

E5776 is really a good gadget. Even Digi bundled MobiFi promotion also seeing the e5776 out of stock from their centre, got to wait new stock.

i would like to know who is the oem factory for aztech...

choose network mode: 4g LTE only (or other similar terms) in router setting

u can test 'auto detection' first.

if not satisfied, back to 'Manual'

country: malaysia
telecom: celcom
3g/4g network: 'LTE mode' should appear in the drop down box
then key in the APN name, dial up number at below.

already select> Malaysia> Celcom: still only got wcdma/hspa and cdma only?

if so, this router firmware not updated, need to update the firmware.

else, easy way juz pick other telco name (not important), maybe from malaysia, maybe from singapore, as long as it show a LTE mode for u to select under the drop down box.

and then remember key in correct celcom apn name & dial up number, save it, should be fine already.

dhcp server is router itself, no need modify. just enable.

dns server, if don want use celcom one, can put google dns: primary 8.8.8.8 secondary: 8.8.4.4

ya, who knows ...

hopefully redtone, Yes, P1 roll out their LTE this year, don delay further

in 3g era, we saw 4 main contenders maxis, celcom, digi, u

wimax, only 2+ 1, YTL vs P1, redtone at east malaysia

would like to see what the market look like when all LTE licensee roll out

maxis vs celcom vs digi vs umobile vs YTL Yes vs TM P1 vs Redtone vs Altel ...

and the broadband (and promoters) war at fair event/shopping complex...

unlimited wifi sim by u-mobile?

1) check your sim card is 64K or 128K
2) subscribe to Maxis LTE-enabled internet plan (not all plan got LTE)
3) set phone network mode - if got manual mode 'LTE only", else pick "auto LTE/wcdma/gsm"
if all above done, still no 4g, it means 4g signal not able to reach into that spot.

solution is by using 4g repeater. but 4g lte repeater itself is costly now.
* repeater solution is already long history, being deployed in shopping complex, commercial building so that people can make calls, 3g internet inside building*

ya, P1 LTE finally due to launch in april 2016

how's the signal level when u on 4g?

if zero or 1 bar, it could be due to signaling level to weak then phone would trigger auto switch to 3g with better signal level (most phone now coming with auto switch option for 4g (4g>3g>2g), can't lock on this network only. on contrary, for 3g or 2g, we can select network mode of '3g only' or '2g/gsm only' to permanently stick on it)

if lte signal level is ok, data is flowing well then sudden disconnect 4g lte netwok, there could be a lot of reasons.