Hi Everyone!
Juz 2share...my latest
DIY done successfully 2day...
This is a
Headlamp Warning Sensor Buzzer Module that will sound a Buzzer if the Ignition Key is turned to OFF when the car lamps are still ON.
There are 2 versions of the module. The other version comes with an extra sensor feature for the removal of the Ignition Key as in ole gen hi-end Sagas & Iswaras.
» Click to show Spoiler - click again to hide... «
Pic #1 : The Headlamp Sensor Module attached to side panel below dashboard on Driver side.
[attachmentid=2859037]
Pic #2 : Fusebox inside Car Cabin...opened to show connections.
Note :
One Green cable is ACCessory sensor cable connected to Power Socket fuse (Can see the yellow 20A fuse?).
The other Green cable is the Ground cable connected to the bottom screw attaching the cabin fusebox aperture piece to the car body.
[attachmentid=2859041]
Pic #3 : Special Red connector to tap (w/o cutting of cable) into cable connected to Headlamp fuse in Engine compartment. This is to connect the Headlamp Sensor cable to the module.
Note :
In my case here, I oledi hv a cable connecting a strip of LEDs in my FL grille to the Engine compartment fusebox. So me juz tap into that cable...
[attachmentid=2859043]
The module itself comes with all cables labelled clearly and instructions to install. However, I could not use those instructions as they are related to an Iswara...
That's it!
Anyone interested?
ps. Most of my time DIY-ing was spent "
hunting" for the correct fuses to connect sensor cables from the Module.
pps. Anyone interested may search in LYN Automotive Garage. The seller calls himself "
Cyanboy".
Now, This is a good DIY... thanks for sharing..
May 18 2012, 11:44 AM
Quote
0.0538sec
0.38
7 queries
GZIP Disabled