overclockin i7 2700k on asrock z68 extreme3 gen3, noobies
|
|
 Apr 9 2012, 09:01 AM
Return to original view | Post
#1
|
 
Senior Member
4,042 posts Joined: Jan 2011 From: Alor Gajah, Melaka  
|
QUOTE(slap2begin @ Apr 9 2012, 01:57 AM) woooo now my h80 radiator become so hot and the temp increase to 80C Did you remove completely old thermal paste on both surface of CPU and cooler? Tuniq Tx-2 should able do the job.. What casing and airflow setup that you use?Added on April 9, 2012, 1:59 amwant to test later so sleepy next time will test  |
|
|
|
|
|
Apr 9 2012, 07:35 PM
Return to original view | Post
#2
|
|
Senior Member
4,042 posts Joined: Jan 2011 From: Alor Gajah, Melaka
|
QUOTE(slap2begin @ Apr 9 2012, 07:18 PM) yes already remove all the old thermal paste and apply a dot of tuniq tx-2 on my cpu...im using corsair graphite 600t ...my h80 using airflow pull and push inside the casing Have you tried the airflow diagram as below. Blue for intake while red for outlets.Attached thumbnail(s) 
|
|
|
Apr 9 2012, 08:25 PM
Return to original view | Post
#3
|
|
Senior Member
4,042 posts Joined: Jan 2011 From: Alor Gajah, Melaka
|
QUOTE(slap2begin @ Apr 9 2012, 08:22 PM) but right now im not putting the side panel yet did the air flow still important even im not putting the side panel ? Try in closed case. |
|
|
Apr 10 2012, 12:10 PM
Return to original view | Post
#4
|
|
Senior Member
4,042 posts Joined: Jan 2011 From: Alor Gajah, Melaka
|
QUOTE(slap2begin @ Apr 10 2012, 12:36 AM) corsair dominator1600mhz That near enough to 1600Mhz.Added on April 10, 2012, 12:43 am already set it to xmp profile and it becomes 798.3 not 800 |
|
Topic ClosedOptions
|
| Change to: |  0.0175sec
 0.45
 7 queries
 GZIP Disabled
Time is now: 2nd December 2025 - 10:51 AM |
Quote