Outline ·
[ Standard ] ·
Linear+
-+-LYN Official Proton Persona Owners Club V34-+-
|
TSngeo88
|
Mar 6 2012, 10:11 PM
|
New Member
|
QUOTE(V12Kompressor @ Mar 6 2012, 10:09 PM) way more quiet than my previous straight flow. Its like 10000% quieter lolz XD Added on March 6, 2012, 10:10 pmsam's muffler tip too small. me dun rike. but klee ayam extractor stock muffler only sound at extractor, muffler as quiet as stock ...
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 09:25 AM
|
New Member
|
 nice score, yesterday ....today target page 45 at 10:00pm, so we have 12 page to spam for V35 on next week. Added on March 7, 2012, 9:31 amQUOTE(Cavino @ Mar 7 2012, 09:20 AM) And the extreme satisfaction of someone cheonging me until toll booth, then after toll the increased low end acceleration makes me runs way faster before the cheonger finally chase up. Before that, damn frust seeing these cheonger unable to cut me, then reach toll booth, from slow position zoom past me while my auto futilely try to accelerate ahead from near stop speed... cheoger is wat kind of car ? btw 2.5krpm @110km/h powe feel really good, can feel the power pushing the back, at that rpm will not feel noise, just feel smooth and power. This post has been edited by ngeo88: Mar 7 2012, 09:50 AM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 09:38 AM
|
New Member
|
QUOTE(Fubar20 @ Mar 7 2012, 09:34 AM)  Suma gila punya spam kat sini. He should meant those buttseker car lah.  i wan ask Cavino wat car he outrun
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 09:52 AM
|
New Member
|
QUOTE(abong8 @ Mar 7 2012, 09:39 AM) Aiyaaa, so tired spamming need to turn back to V25 again..  typo lah , so Prof. Dr. Abong wat is the conclusion of yesterday research of green technology engine.
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 09:57 AM
|
New Member
|
QUOTE(Cavino @ Mar 7 2012, 09:46 AM) Saga, Myvi, Vios.....these are the cars that like to cheong ppl...no bmw or its like lar....if those cheong me, usually I step aside rather than accelerate, what can 70+ hp do..... Mmm...I think if all goes well, I might be installing stiff ring on Saturday before my 15K service to see if it solve the up/down ramp steering shaft and below clang clang noise... Heard some say bolt from subframe should not remove coz once remove, it will easily loosen next time compromising the subframe...not sure if its valid...so another doubt there....cautious me just cannot install anything without worrying this and that... your car still new and it should be no problem, if those car after few year maybe will face the problem, if you wan ring u better pre-order because the ring was not sell at the shop, need order than the seller will bring it to the shop for installation. Added on March 7, 2012, 9:59 amQUOTE(Fubar20 @ Mar 7 2012, 09:54 AM)  Want to repeat again meh? I read until want to vomit liao.   i dun wat the research report lah, just wan the final conclusion ...the name of the green engine. This post has been edited by ngeo88: Mar 7 2012, 09:59 AM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 10:28 AM
|
New Member
|
QUOTE(Cavino @ Mar 7 2012, 10:20 AM) Haha...I tot its those cars with a few years life that benefit the most from stiff ring installation... Anyway, will arrange with Chin (the seller) if decided to install this week. A bit far lar this panel shop at Cheras. Have to travel far from Klang on Saturday. Hopefully at 11:30 to 12pm, Kesas and its road to Cheras ain't jam like shit.... it work good for new car too, if install at old car the result more noticeable, before 12pm is still ok after 12 mrr2 will jam at bdr tun razak, oh btw it depend on the car, my car subframe was not streight and it was corrected by wheel alignment all the while, after install the ring i need to re-do the alignment because the stiff ring corrected my subframe hence now my alignment is off, but not for all car, zeng car was no problem for it.
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:18 AM
|
New Member
|
QUOTE(huat0823 @ Mar 7 2012, 11:14 AM) get poison ady... wanna install Stiff ring at next week. anyone wanna install also? Cavino plan to dot it this saturday pm him and get in touch at can go together.
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:21 AM
|
New Member
|
QUOTE(V12Kompressor @ Mar 7 2012, 11:20 AM) starts to be noisy, but at least not as noisy as my previous straight. if you're expecting hybrid like silent then, it is not. this sat where u guys TT, can see your muffler
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:22 AM
|
New Member
|
 P3-21A is now open for booking at all Proton Edar branch.  Added on March 7, 2012, 11:25 amQUOTE(V12Kompressor @ Mar 7 2012, 11:22 AM) Puchong might switch place from Asia Cafe to Tai Ma opposite Tesco Puchong the hokkien mee there  very clouded wan where got place, go puteri ba.....lot of parking place behind the public bank there This post has been edited by ngeo88: Mar 7 2012, 11:25 AM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:30 AM
|
New Member
|
QUOTE(VincentChen @ Mar 7 2012, 11:28 AM) actual spec, look and price also havent see how to book wo that's the reason why i mention here telling all member can go ther to dig out some actual spec and price instead of tell you go buy.  Added on March 7, 2012, 11:44 am WTF jelly jellyThis post has been edited by ngeo88: Mar 7 2012, 11:44 AM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:47 AM
|
New Member
|
QUOTE(shelby_yong @ Mar 7 2012, 11:44 AM) tao apa price ma? maybe i going book also. so become the 1st owner in lyyn?? haha tak tau, latar u go see see lor....
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:48 AM
|
New Member
|
QUOTE(jackyap84 @ Mar 7 2012, 11:46 AM) i do have same feel with u. low end torque is very bad for auto... so wat are you waiting for go get LCP Zapdos also intrested. Added on March 7, 2012, 11:51 amQUOTE(shelby_yong @ Mar 7 2012, 11:48 AM) working ah.. erm.. maybe give a call to them. haha working no need eat lunch meh... This post has been edited by ngeo88: Mar 7 2012, 11:51 AM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 11:59 AM
|
New Member
|
QUOTE(Fubar20 @ Mar 7 2012, 11:54 AM) No point jelly. You no same colour one very difficult to get in nia. i jelly to those same colour wiht me but work inside, most of them are at the Dagang site but not engineering, engineering got few of I races too. Added on March 7, 2012, 12:01 pmQUOTE(VincentChen @ Mar 7 2012, 11:56 AM) what ish proton edar, can i go to any proton dealer to see the car? car no have need wait until launch, brocher also no have maybe only got price list nia. This post has been edited by ngeo88: Mar 7 2012, 12:01 PM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 12:19 PM
|
New Member
|
 P3-21A still using same size crank pully as Persona, so our LCP can be transfer to P3-21A engine. sos
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 12:28 PM
|
New Member
|
QUOTE(que0788 @ Mar 7 2012, 12:24 PM) kweng's all types of car exhaustsanyone recommend this?..its reall cheap.. yes is cheap but there are some negative comment to his workshop too, after that his work shop change another name, try search more of his history from diffrent forum.
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 02:23 PM
|
New Member
|
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 04:12 PM
|
New Member
|
QUOTE(Fubar20 @ Mar 7 2012, 04:03 PM) Ada link for website kah? Added on March 7, 2012, 4:04 pmTry COSE. If sana also no have then maybe it is true.  go tanjung malim production office roll on the floor and cry i wan PE m-line stick shifter This post has been edited by ngeo88: Mar 7 2012, 04:13 PM
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 04:43 PM
|
New Member
|
QUOTE(VincentChen @ Mar 7 2012, 04:33 PM) no need roll roll, threaten them and say if dowan gimi stock bear bear gona bite your daughter  Added on March 7, 2012, 4:34 pmi think so too, she can even say just lil bit crack, gib u RM50 and go paint urself bear bear gonna head you daughter it is true aunty see this small case only, later she bargain the price like buy vagie at pasar.
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 06:06 PM
|
New Member
|
QUOTE(dares @ Mar 7 2012, 06:04 PM) Worked with Cavino...  Cavino got young daughter ma
|
|
|
|
|
|
TSngeo88
|
Mar 7 2012, 06:17 PM
|
New Member
|
you guys know how bear sistar look like..... » Click to show Spoiler - click again to hide... « look like a bear This post has been edited by ngeo88: Mar 7 2012, 06:17 PM
|
|
|
|
|