use a driller =X i remember mikatan post about it before

Step 1: Find electric drill
Step 2: Uses smallest bit, drill in at a slight angle, not too deep, and pull it out.

Also works with the small hand-type thing used to make holes for screws. I find those are a little too big for this purpose though.

Note:
- Since figma joints are much smaller than nendoroid joints, you may need to use a very fine drill bit.
- With the electric drill you're basically making a clean hole in the joint, hence drill at a slight angle so you can pull out the bit stuck inside
- This only removes the joint lol, mikatan's guide is better if you actually want to fix it.

Source:
Mikatan's blog
Personal experience

---

Added on February 19, 2012, 10:53 pmlol I finish type baru realize chizzu post link to mikatan tutorial orz

wow....put nendo in the sand make them dirty

can you post the picture here, my uni internet is blocking it, suspected adult site lol

Thank you for your continued support of Good Smile Company products!

This is to inform you that the following products that were sold from the 11th January 2012 will be shipped on the 29th May 2012:

Nendoroid Luka Megurine: Cheerful Ver. (Good Smile Company)

is there risk of custom tax if I pre-order 3 sonico from gsc online shop?? hmmmm

hmmm... 12500 yen is less than RM500, should be ok I guess... then again, I'm wondering, they say these collectibles are not taxable, and if they tax u, can u fight back to have the tax lifted?

hm, i see on GSC website for the release of super sonico, its 3500yen, plus shipping 2000 yen, which is 5500yen, which is around RM200, so u mean buying locally would b even more expensive than this? i thought local stores are only selling nendos at around 1++? correct me if im wrong

LOL... i know is this month... 
guess i should change my question....

"is saber motor released at the moment?"
because up until now (05/05/12) and she's not yet released....

^^^^^ ;u; Mine has been on "handover to airline" for 2 days now