means a lot of cars with 800c pads now has plunged down the hill?

smell is the least of your concern. easy to overheat means very easy to Brake Fade.

now pakai Caltex.
can say engine more quiet than Esso. When revving till 5,500 at KESAS just now can hear my supercharger CVT whining sound only.

When the F10 BMW 5 series makes its debut, all assembled in Germany models worldwide, including Malaysia is plagued with a faulty absorber issue.

Current gen Honda Civic first batch also got problem and those problem are only rectified 3 years later, after numerous complains and some even korek dompet to replace the faulty part. And that faulty part isn't cheap. It costs four figures.

and I dont want to get started with Toyota's "Moving Forward" story.

tak mau ah.

my horn spoil also can claim. Somemore my wiring so obvious. haha

RM15 with waterproof protection without installation.

banyaklah kau. mentang mentang tinggal kat seberang jalan saja. I have to travel more than 30km one way.

the wheel bearing problem.

brake fade is a situation where you lose all braking force completely eventhough the brake pedal is fully pressed.

would be kinda "pilih kasih" if i posted this in persona thread instead of the proper place where it should belong;



100% DIY.
any comments and critics are welcomed.

asal u mindfark?

to make a cake, you need a mould.

apa ke-lala-an ini?

ching chong ning tong nang ting tong chang

去死

nah

吹水

this also not bad.

mau bulk?

打飞机一流

1.
2.
3.
4.
5.
6.
7.
8.

lai lai bulk.
RM10 each. Size is 5 inch x 2 inch

This post has been edited by V12Kompressor: Feb 23 2012, 11:17 PM

kenot put "lancap nombor satu"

nanti kena tahan pulis. THen the pulis call lancap tepi jalan then jialat.

This post has been edited by V12Kompressor: Feb 23 2012, 11:20 PM

nice, but I've personally seen one at COsE.
looks more gorgeous in real.

This post has been edited by V12Kompressor: Feb 23 2012, 11:25 PM

which proper car?

---

Added on February 23, 2012, 11:59 pmcan call and check out the proton spare parts center at Glenmarie.

but be prepared. Original proton bodykits aren't cheap.

This post has been edited by V12Kompressor: Feb 23 2012, 11:59 PM

nonid this

come bulk that ta fei kei one.

technically, it is not half. But it wont go down fully because the back glass is one piece glass, not two piece glass like those in bigger cars like the Camry, Accord and Teana.

then what makes you think you wont be dumping money (probably more than the BLM) on your choice of the car too?

so you're willing to do the above mentioned for a Nissan which is almost as old as you but not on your current car?

how naive.