4 bikes for u then

Naza blade 250r - about below rm20k
Ninja 250r - about rm21k
Cbr 250r - about 20k
Naza blade 650r - about below 30k

Price around there plus minus.

kereta baru dah keluar, harap harap motor baru keluar bulan ni...lulz

Gsx 600 brand new dp 20k monthly rm850 7 years ok ke ?

Oh wait itu aeon credit.. But if shop loan he said annual interest 4.3% and dp rm23k so im not sure how much monthly

This post has been edited by ImSIEBEL: May 3 2012, 11:36 PM

Gixxer 600 yg SE kan rm65k je

Owh baru dapat tau asal motor murah giler kat semua tempat.. Imported used aka recon.. Tu la pasal gixxer 600 imported new harga rm88k.. Tak tau la pulak pasal ni.. Lolololol

Sebab member aku ada kedai, so ingat nak ambik kat dia je kasi settle loan kedai, so dia bagitau dulu sebelum i beli pasal benda ni.. Check semua, model chassis 2009, mileage less than 5km...

. Btw ni tak tau cerita betul ke tak tapi dari 3 source yg bagitau aku la,

Semua motor naza memang US spec, kecuali yg latest model la ie 2012.. Tapi motor mana mana US spec, cut off beza dgn UK atau Japan spec, US ada drop min 20bhp dari UK atau Japan spec..

Btw just got back from my friends shop, takde stock la pulak utk yg gixxer 600 tu.. Sekarang dia bawak semua motor model 2012 only, gixxer 600 and r6 for rm89k otr with interest 4.3% only from shop loan but min 30% deposit required.. So tak dapat beli dari dia..

But no worries my hunt is still on, member punya boss taukeh AHM, dia ada gixxer 600 SE for rm65k also, tengah tunggu confirmation dia besok tgk ada stock ke takde

Because i know the boss at chear motor kota damansara, i service my bike there, plus my friend bought 2 bikes from him, a ninja 636 and a harley nightrod

1. Er6n maintenence is quite cheap actually, below rm200 depending on what engine oil u use

2. Blade bikes spareparts are quite hard to find, but usually around KL no problem..

3. Ninja 250 and blade 250 are in same category but prices are different, if u can afford the ninja then go ahead, safe headache.

if i were u ill just get the blade 650r.. Harga yg cukup menarik dan power pun ada


Motor baru tuu, Plate WWC

How much to do valve clearance and where best to do for ninja 250 ?

boleh la pulak member aku accident depan mata aku, nasib dia ok, satu calar pun takde, cuma pakai glove, riding boots and helmet..






happened at tol penchala, basically the teksi park infront of the exit of motor lane, only put cones to cover his car without any hazard light, my friend pulak was looking down at his bike not paying attention at the front because he was checking his signal light apparently langgar the motor lane punya cone.. i tried to horn at him but he didnt manage to evade terus booooom langgar belakang that taxi and landed on the roof of the taxi.

taxi owner not there just left his taxi at the side of the road.. but he should park right at the side not just left there in the middle..


Moral of the story, Always pay attention on the road..

This post has been edited by ImSIEBEL: May 7 2012, 10:54 PM

this wednesday nak beli nombor la..

bila nak TT ni ?

Friday tak leh, gi tgk russell peters

Tak kot lexus kakak aku bawak, aku bawak kereta aku je la..

Ko duduk belah mana ? Aku duduk belah kanan

alaaa ada orang dah bawak keluar gixxer hitam, boleh la gi makan ikan patin

Kalau camtu aku pun nak ikut hahahaha

Kalau ko report kastam pastu dia tarik motor ko dapat reward rm5k cash !!$$!$!$!

Tempat aku lepak banyak motor SG, kang satu daripada diorang buat aku marah memang kena ah.. Lololool

perghhhh memang er6f 2012 memang hidung berdarah, seriously looks good.

but then again, i wont go for er6f, ill rather have a real 600cc bike that feels and responds like a 600cc bike..