Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 Reasonable price for Wira radiator fan motor, Work shop charged me RM 215, expensive?

views
     
amad108
post Jan 18 2012, 12:37 PM

too much of something is bad enough
*****
Senior Member
998 posts

Joined: Jan 2005
From: Shah Alam SDE


QUOTE(DiamondBar @ Jan 18 2012, 03:13 AM)
I sent my Wira to replace radiator fan motor (Nippon Denso brand), the car workshop
charged me RM 215 for part and labor, was it expensive?

Also to replace Wira clutch cable, they charged me RM 125 for part and labor, was it
expensive?

Thanks...
*
it is expensive bro.. for job like this the labor around rm20..
parts value only rm60 for fan motor, and rm40 for clutch cable.. both actually easy to install.. even me tried DIY last time.. wink.gif
amad108
post Jan 18 2012, 01:24 PM

too much of something is bad enough
*****
Senior Member
998 posts

Joined: Jan 2005
From: Shah Alam SDE


its ok bro.. just avoid them for a while.. try ask ur good friend where they service their cars, hear their feedback about workshop they have went..

last time i only buy half-cut fan motor, cheaper and for sure japan original which a lot better compare new one malaysian made..
even last time my friend engine valve inside all bend oredy, buy new one from spare part shop, after done install it, wanna try start the engine, all brand new valve bend again.. whoo.. sweat.gif sweat.gif , dont know wht to say ler.. then buy 2ndhand at halfcut shop, install n start the engine no issue..



This post has been edited by amad108: Jan 18 2012, 01:28 PM

 

Change to:
| Lo-Fi Version
0.0146sec    0.72    6 queries    GZIP Disabled
Time is now: 29th March 2024 - 12:21 AM