Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

 --+-- PROTON SAVVY LYN club V4 --+--, New thread after 2 years,2 months,27 day

views
     
v3t0
post Jul 22 2013, 09:32 PM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
QUOTE(fa-tin @ Jul 22 2013, 03:09 PM)
hello all sifus out there,

need your urgent advice about my savvy AMT problem. i found that when i climbing the hill with really high slop or climbing to the roof parking of certain building (#shopping complex) during traffic jam (i mean crawling the hill really slow), there is beeping sound with gearbox indicator lamp is ON....then i can smell like a burnt...so anybody can confirm what's going on? i'm driving savvy AMT 2009

please help
*
Probably your clutch plate is out. Its time to change full set clutch kit. Please expected around plus minus RM600 damage in your pocket.
v3t0
post Jul 24 2013, 05:26 AM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
QUOTE(fa-tin @ Jul 23 2013, 08:33 AM)
cry.gif  damn...is it true...? which one : clutch plate or AMT motor kaput? but it seem no problem when in normal driving condition...only happen when climbing really steep hill/building... thanks anyway v3t0 and pizzaboyi...any other comment? at first, i just thought it only the matters of electronic sensor that detect the car driving slowly (or stop) at steep hill  sweat.gif
*
Did you experience any clutch slip while climbing hill? The symptom of clutch slip is when you driving your car, suddenly the engine roaring like a hungry lion.
Try to use manual when climbing. If you dont have any problem using manual, then the AMT coil is kaput already. AMT coil can service nowadays If you come to the correct workshop. Just replace the coil. Think less than 200
v3t0
post Jul 28 2013, 08:32 PM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
RM5++ to replace clutch kit including labor charges is consider cheap..where is it davidke?
v3t0
post Jul 30 2013, 05:41 AM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
Some said that gauge failed because of the resistor..replace resistor should resolved the problem..but not sure how true is it..
v3t0
post Aug 1 2013, 11:01 AM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
QUOTE(fixgd @ Jul 31 2013, 11:13 AM)
how much do u expect if some one wanted to do this service? i was quoted 850 for this, but have to travel to melaka.

*  TIMING BELT + TENSIONER BEARING + 2 PCS OIL SEALS.
*  4PK1540 AIRCOND BELT
*  3PK750 ALTERNATOR BELT
*  WATER PUMP.
*  2 pcs AIRCOND BELT BEARING
*  COOLANT 500ml x 5
*  DTC DIAGNOSTIC
*
Reasonable..
v3t0
post Aug 6 2013, 12:16 AM

Getting Started
**
Junior Member
95 posts

Joined: Oct 2010
Very hard to find after market ECU. Maybe can ask PESC. Might cost you bomb. Hehe

Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0437sec    0.36    7 queries    GZIP Disabled
Time is now: 30th November 2025 - 04:58 PM