Local prices = Item price+shipping+tax+overhead+profit

Online = Item price+shipping+small commission.

pening kepala searching at this HobbyKing website.
i'm looking for 4way Wrench, Hexagon Driver, Screwdriver +/-
Is it ok to buy battery from this website? do I have to change the connector?
the connector on my car still using the stock connector the white one. afraid won't compatible

This post has been edited by dan137: Jul 9 2012, 02:13 PM

What you are looking for should be under tools/hardware.

I've bought quite a few LiPo batteries from HK with little to no fuss. And its highly advisable to change your connectors to the Dean/T connector. The original Molex/Tamiya plug wont cut it. If you do plan to buy, would it be possible for us to COD? That'll keep your prices down too.

ahh..i see.

If i have to change the connector, that means i have to get a new charger too.
I plan to buy those things but, maybe later. saving some money to get all in 1 shot perhaps. maybe i'll be joining ur shopping spree at HK later.

The balance charger has several different leads, so different connectors are not an issue.

Do let me know if i can be of any help

i sure do need a lot of helps. regarding the digital balance charger (the features, programs, function,etc), heat shrink tubing size, how to solder, size of dean/t-connector (if any), size for all 4way Wrench, Hexagon Driver and Screwdriver +/- that suitable for RC buggy n heli.

Balance charger : Read manual. But basically, you MUST NOT charge LiPo in NiMH mode and vice versa.
Heat Shrink Tubing : 5mm? I'll have to double check
T Connector : Standard size. no worries/
Hex driver : Buy a set for various hex, most comes in 1.5mm, 2.0mm, 2.5mm and 3mm. For wheel nuts, you'll need 7mm.

Proof that offroad is awsm

BUMP!

bump again

My turn. BUMP.



This post has been edited by dan137: Jul 15 2012, 01:36 AM

Turnigy 1/10 Short Course Truck









Come with -

Adjustable camber, caster and shock mounting positions
Adjustable slipper clutch
Full-time 4WD system
Low center of gravity chassis design
Pre-installed 45A brushless power system
Front/Rear and side impact bumpers
Pre-painted and trimmed body shell w/decal sheet included


Specs:
Length: 530mm
Width: 295mm
Height: 220mm
Wheel Base: 330mm
Motor: HK 3100KV brushless (3650 size)
ESC: HK 45A
Battery Tray: 167mm(L) x 50mm(W)

Add own battery + RX.

PM me if interested.

so diam this thread

mau jual ka ni? how much?

With s+h, would end up somewhere at ~RM650 or so...

nice SCT..would you PM me the price of kit + bodyshell + tire (without electronics) ?

greetings all..

just moved to offroad..and using Axial EXO Terra buggy..hope to know u all..


Attached thumbnail(s)

PM-ed

Cantek. Bila nak gi bashing?

dah bashing2 ni..tayar da kotor..hehehe..titiwangsa je..