the skeleton red colour look funny though look like i need to spray can when my unit reach me

anaklusmos look fugly to me and too simple

the front pat between the leg

This post has been edited by stupiak07: Feb 16 2012, 01:30 PM

whoa so much detail

feel more like a test unit

This post has been edited by stupiak07: Feb 17 2012, 11:28 PM

it would be nicer if using sniper rifle+a different head

This post has been edited by stupiak07: Feb 19 2012, 11:00 PM

anyone know where i could get those bright silver paint like the astray red frame sword? and brand and its code(if got)

want to cover the nip mark

This post has been edited by stupiak07: Feb 24 2012, 05:48 PM

you could find stationary shop also, normally at pen shelves

at the top of the cap got write the size of the head

find those 0.1 or o.05

edit : most common brand is faber-castell, for more study 1, go look for micron

This post has been edited by stupiak07: Feb 24 2012, 05:57 PM

thx for info

added led
cost 50cents only + some left over thin wired

mg aile strike head


This post has been edited by stupiak07: Feb 28 2012, 01:04 PM

you could pack it in body also with mini switch and glue/cemented body.

-for the led and battery, go find those 50 cent gahapon for finger led
(just need the 2 battery+led+metal part)
-get few more for spare battery
-it's better than buy a new led which cost rm1+ and new battery(duno cost how much)

for strike only

1. cut the top part of led (mean halved without damage the metal part) so it can fit in
2.u need to remove some part of the inner head(above the PC part) for the led to fix in it
3.drill a tiny hole at the back of the neck the body part for wire to go thru
4. remove the some part of inner part of inner body frame to allow battery to fix in
5. for the switch, you could hide it at the body back booster(which you could take it off to switch on and off).

or u could put the battery in the back booster (for easier replacement battery) but that mean you need to mod your back booster a bit and without switch
(which i will try later)

This post has been edited by stupiak07: Feb 28 2012, 01:50 PM

any sample the eye without transparent part? and which scale was it?

This post has been edited by stupiak07: Feb 28 2012, 01:55 PM

know that as long it's dark colour is okai.

still waiting for my airbrush set from tkting before start paint it

---

Added on February 28, 2012, 4:57 pmwhat i recommend is that u need to remove eye part only without damaging the other area.
and then get half transparent pvc from book shop to cut the sharp out and glue it to the missing eye part

so you need to very carefully doing this part or else your gundam face spoiled.

---

Added on February 28, 2012, 4:59 pmsince it's hg i recommend you use transparent fishing line so that the light wont be too bright



led-------------eye (or add a small crystal at the eye)
----fishing line

This post has been edited by stupiak07: Feb 28 2012, 05:00 PM

how much u bought the command wolf?

This post has been edited by stupiak07: Feb 28 2012, 09:39 PM

chill~ here isnt business section

your red frame kai vs smile trooper

from the hilling care garazzo runner, it doesn't look much different as both unit part is identical

i think only the head is different

confirmed only the head is different

---

Added on February 29, 2012, 8:38 pmhere the runner colour


This post has been edited by stupiak07: Feb 29 2012, 08:38 PM

those gold from which brand? and code?

shit damaged the astray finger, didn't know the hole so small when try to bend it.

and the freaking loose thumb of both hand

it should be around astray red frame kai price

lucky didnt PO it. the quality is so bad from the pic

does anyone break part of MG epyon yet? since i found out a lot thinner part and might break if using slight force especially the shoulder part there.

the colour of daban look like matte ver of bandai unit

This post has been edited by stupiak07: Mar 15 2012, 08:57 PM