gundam paint

At least shows the image of ur current case situation and the placement of ur hardwares.....

ericmaxman, from my previous UV project, I located one 30cm ccfl at the bottomof the casing, and another one on the innerpart of the sidepanel, juz beside the screws holding the acrylic layer. double sided tape bundled wif the ccfl is needed for dat ar.. or if u dun mind, juz throw in the ccfl without adjusting it. (datz wat my housemate did...uuhuhuhuh).. but yeah, Doom's suggestion is recommended 1st. I myt wanna get sum fresh ideas from forumer here too..

ahahaha, i didnt remember saying dat i posted my uv rig here.. coz itz juz too sux compared to other forumers'. uhuhuh.



hence, the name *incomplete UV setup. but I'll still give u a sneak peak at it la k. uhuhuhuh

This is how it looks like when I put the ccfl at the top n bottom. very2 dark effect.. sigh  in my case, the top ccfl's ray is blocked by my PSU and HSF.. sigh!~


this one is where i put the ccfl, one at left part of the sidepanel, n other 1 at the bottom.


this one makes it obvious dat sumthing is hot at the mosfet area, burning my Freezer64. uuhuhuhuh

datz y now, I'll start my new UV project once i get all the materials ready later on.. uhuhuhu

i didnt put it at the back of the casing (the exhaust fan area) ar... I stickd em on the sidepanel. hope dat helps..

wah... ...how did u do dis??? no cutting???  please tell me!!!

@ericmaxman
I got mine Rm39....XDXD