Walao! U people no be potong R&D team wasted.

problem i say d...there is no ori/actual cover for the hole.....so u just find any plastic and diy only lor

---

Added on December 22, 2011, 2:47 pmI WANT....but this 1 need protong wire...so kenot touch yet...........sigh

This post has been edited by stewPik: Dec 22 2011, 02:47 PM

actually too good to be proton ppl..haha

U worry void waranty but want install push start.. lolz

---

Added on December 22, 2011, 2:48 pmI will tell u... kenot add geh.. stadard macam tu??

This post has been edited by K3nnYkl82: Dec 22 2011, 02:48 PM

Can I put two of the same switch side by side? Make it look full & complete?

BTW if Other switch can be used for ejecting MIL out ..qqmeng would love this..

what do u mean same switch ? 2 lock button ? CAN...u PAY for it only ma....hehe

Say.... Proton dont have such simple plastic cover available?




Attached thumbnail(s)

That one too tall.... not flat geh..

Actually what is the use of pust start button?
We still have to put in car key into the hole, might as well just turn it to start the car?

Btw Kennie, u have answer my question...
Is my Asc and the buttons beside the headlamp switch ready?

fren.....this cover is for that LUBANG, now we go BUKA a NEW lubang...where wanna find the cover ? when it doesn't exist

Like 90% of the mods... no reason other then to shiok sendiri

When u wan pasang. will get it done for u.

ooooohh..... i understand... actually i dont.. nvm nvm tomorrow discuss!

This is what happen. I arrive there check the car externally and the interiorand confim all is fine so I just signed the paper and drove off. As I was driving almost halfway back suddenly the SRS Airbag error popout and it says "SERVICE REQUIRED" on the screen. After a while it went off, then it came back on again. Throughout my journey back home I think it appears for 4 times at least. Engine light also came on but just for a while and it went off the 2nd time I took the car out for a ride.

The loud "lorry" sound apparently is how the original engine sounds like. K3 says is normal and this is where his custom mapping can make the sound not so rough because the engine would rev more smoothly with power kicking in earlier. The stock mapping really suck seriously.

I think from this experience before you signed that the car is good tell the SA you want to take the car to drive a few rounds first before signing the paper.

Oh yeah, the Clarion HU is really bad in radio reception can hear hissing sound occassionaly.

Buy two switch frow stewpik for those reeeech ppl here lo. Then can fit nice nice, no?

lol..joking

Same here.... but this time I ALREADY put in the antenna liao.. same problem... ceh

AGREED

Thanks for the heads up mate....

Truth to be said, I was indeed thinking of going for a full ride with the SA prior to signing off them documents.

I will watch out for the pointers you mentioned on them SRS Warning , Engine Light and etc.

SANGAT BORING IN OFFICE ~~~

its normal la, after waiting eagerly for our new car sure cant wait to drive off, any probs just go back to SC to get it rectified . so far they'll layan us nicely