Pentas 2/3 only bad thing is no confirm fencing ... only rumour will have it in future. Other than that there is no major disadvantage for Pentas 2/3. B/U large, ~Rm230-Rm250/ft. Build quality good.

I like end/corner if can afford For number like 4, etc I am still ok as you can chg to 2A, etc. No chg also ok as I dont see an big problem.
The only concern for me is T junction unit .. or F1 cornering unit. These type of units will be harder to let go in future. You should discuss Pentas in Pentas forum. Here is TTDI.

Directors sapu half of the units? Now release?

Wow! 1.6M vs 0.8M launched price almost 2x in 2 years. Must be day dream!

Do we need to paid 7% upfront in order to get the 3%?

Can u tell what is ceiling height?
Do you have master bedroom pict?

Show unit for developer inspection normally will be completed fast. The rest will be slower.

Last 2 week, I passed by Kampung Jawa at the back entrance to AI (close to Econsave) noticed some shop lots and small scale factory got flood.

This post has been edited by Ang Ang: Nov 12 2012, 04:31 PM

Would like to share my current Taman RA setup G&G with individual title. About half year ago, RA install Gate with access card system. For those who did not pay, they have to use another entrance gate and sometime guards ask to write down their name which make them feel inconvenient.
However gate system being removed due to one resident complaint. Lucky we managed to put back the gate and access card system in one week time with conditional approval obtain from Majlis. As of now, for those resident who did not paid, guard have to open the gate for them without any delay. Else gate and access card system will be removed.

You can actually ask plumber to disconnect the water flow from tank to car porch. Can stop ater flow at tangki. And install new pipe from meter to car porch.

Anyone know when is the key hang over date for Sephira? I almost bought Sepira 2 years ago, the selling is very fast. My 1st visit was in June 2011, it only has few units left, mostly corners. Can't really afford.
I end up buying Pentas launched in July. Key not yet deliver yet.

Rgd quality lockset, how to judge and differentiate? Perhaps the unit you checked out was temporarily install lockset. Some of your pictures posted seem like still have a lot of work need to clean up. TTDI is reputable dev, u should not worry that much. Good luck!

Std price for normal design plaster (flat) should be ~rm3/sqft. Some with special design may charge alightly higher.
Is your down light price RM95/nos include lights?
Fan install fee should be ~25 to 30, depend on your fan type and ceiling height. Fan Nos and light nos price shud be around the same price.

Anyway, some contractor may charge higher as they may have better quaity work, etc. All is very subjective.

how many room has connect with hot water piping?

INP new phases also provide Grundfos water pump. Pump cost more than 1k. Alarm by default.

tiles labor price seem reasonable. Kitchen wall ext cost how much per sqft?

My contractor quoted me 1 6x4 window rm680. 18k for how big the extend area? Mine rm28k included concrete table top 28ft, wall and floor tiles installed labor, 2 piping + whole house 2d id drawing. Tiles buy myself. No security door.
Extend size abt 200 sqft.

This post has been edited by Ang Ang: Oct 2 2013, 09:26 PM

look quite reasonable. I prefer to choose my own tiles. I need 2d for cabinet guy. no need go thru middleman.
I have a chance to visit the cabinet guy factory to choose material, cost and visit ready made show unit actual sample. more important need to compare to expo quote.

Your rm120 is per sqft or per foot run? Later should be reasonable.