VS DONT improve performance, esp on new car.... and to get the most out of it., you need to add grounding cables too....

Its mainly to more effectively distribute the electrical charges via the wires, and thus "improved response"... which u can barely feel (if you are looking at performance boost)...

What it does well is you will notice you halogen blubs becum brighter, your radio gain slightly better, your start engine crank becum easier and your RPM dont dip esp when the AC compressor kicks in.... thats all

PM or look for EricTioh for his DIY version of VS and cables, or get REAL Pivot Raizin, not those cheapo fake stuff....



RA snorkel may need slight touch up mod to fit our LGT based engine front cover (as i was told la), and the hole you will need a really sharp knife and patience to cut...

---

Added on December 2, 2011, 11:35 amI think CKK have it.... but he not here now....

I changed mine but never kept track of the part no...

---

Added on December 2, 2011, 11:37 amWafark with your timeline lor?? Last night drink too much ka???

Cum let K3TCSS tune-nia-sing your blain.... or let Potatoes clear your tubes with his TRAIN....

This post has been edited by Poadster: Dec 2 2011, 11:37 AM

You have to cut the hole, i dont think the panels come with that hole precut.....

TQ... i hope you mean the RA snorkel hor....

Me wont be in KL for Xmas, so will collect after that as Boxing Day present, or as 2012 Countdown New Year prezzie lor....

---

Added on December 2, 2011, 11:53 amMore info the better...

Same output as in they LOWER them for LGT too??? I tot LGT have more ponies, thus more output, than Inspiras???


BTW, Pip is asking for the nyek nyek bush replacement part no... do u have it???

---

Added on December 2, 2011, 11:54 amCum lar... scared ar...?? ™®

This post has been edited by Poadster: Dec 2 2011, 11:54 AM

Oh... they are prolly doing it to prolong the engine and CVT life too.... and better FC to most owners are always a better thing....

Only Inspira drivers soh lou smart go add performance push to increase FC....

Only the innards have unsmooth surface due to the fiber material ma.... i doubt this will have much difference in the actual intake, as its much wider and bigger intake if compared to the original....

RM160 vs RM280 = 75% increase in cost, i doubt the fiber snorkel will lose 75% air compared to the ori RA one, no??

However, if beauty, looks, perfection and the Ori-ness appeals to you, and your pockets have the loose change, then get the Ori wan lor....

Lemme check with my SG frens if they have received the 2011 car or not....

And only in MY are there butthurts.... SG LGT drivers are most happy to chat with me on the car.... and they actually love to cum MY to change bum/mods as its pretty cheap here....

Looks very diff.... cum TT tonite and compare NZH snorkel vs XCInspire snorkel... see which you like...

Irregardless of Simota or K&N, any high flow drop in filter will be better than the stock paper filter.... you will feel the low end response better, while the top end roar louder....

You have never cum to the TT hor...??? Ppl will pop your hood irregardless.....

To some ppl, the ori one dont command a performance improvement of 75% versus the increased 75% cost....

Malaysia boleh cari cheaper but ciplak ma....

1 dyno run arnd RM100 (as per what they say la...)... so might as well you get the ori for peace of mind???

Thats y he super scared let LGT knows he sells to Inspira, and he also sells parts to Inspiras more expensive to pacify them super butthurt....

Well... those LGT ppl are his BOSS ma.... he makes profit off of them.... no???

BUT what i dont get is this, its very obvious that Inspira will over run the numbers of LGT on the road, and thus making US his biggest client pool.... but he still screwing Inspira drivers, thus I bring my moolah to other places and sellers....

Well... to each their own choice ma...

BUT... irregardless ori or taiwan, these raised 3 secure points bars are way better than the 2 point UR bars, and the UR bars will crack over a relative short period of time (depending on how aggressive you drive)...

This post has been edited by Poadster: Dec 2 2011, 12:38 PM

They are pretty much the same.... except the Taiwan ones have longer and fuller weld along the pipe meets the O part.... and the ori have arrow to point to the starting screw secure point....

Nope.... initially, we convoy there at least 5 -6 cars each time one of us wanna do stuff.... and we all press him price that if his price is good, we all buy now...

Same face no fark u service....

U go try his "infamous" service lor....

---

Added on December 2, 2011, 12:44 pmIf you donno what and where to look, they all look like the same 1in water pipe welded to two O metal rings at the ends, and painted black....

Chabutzzz.....!!!

This post has been edited by Poadster: Dec 2 2011, 12:44 PM

Wah... need to plan plan wan meh??

930p onwards, Old Town Coffee in 3Two Square, Sect 14.... behind the mosque and next to Toyota 3S center...

Kena halau oso still stay outside till way late lor....

harlow.... u think Forte is dead ka??? way more gadgets than Inspira wor....

Sorry arrr.... which car are you driving???

Inspira CVT dont jerk while moving up the gears.... only jerk u may feel is downshift, that part oredi explained by ckk125...

To remove the rubber band effect, try look for K3nny to remap your ECU.... belum cuba belum tau....

P3-21A is gonna launch soon..... so will it beat the Smart Guys' car???

Or simply be a revised bumper with revised PP whatever dash moulds only??