Zzoro you sell burger now in ss15 subang jaya?

I am not sure you know this but you are not recommended to run your gc block in parallel due to one being a heat killer another ek. You need to run them in series

If you want to waste money on a ldpc you would end up buying more cards to fill up the empty space. As the ldpc is too big and needs to be fill up to look nice

Ldpc needs to be fitted with 3 480 rads
And the top rad needs to be push pull to fill space

Just an idea of the height. If poslaju delivers a sorry note that you were not home for them deliver the ldpc. Don't hope to collect from the post office. Can't fit the car unless you own an mpv or SUV

The h2 cube should be easier on shipping but still expansive

I only recommend buying an ldpc if you want to do benchmark and skip it if you using your pc for games
You don't need much cooling power. Running a single loop with two 360 rads is great already for CPU and gpu
You can always opt to run 200mm rads also this is close to a 360 rad

Just let the loop continuously and the bubble would disappear after a day
I remember if you a weaker pump then the bubble would remain just rock the chassis and press the tubing

I normally run my pc for 24 hours without the others being powered up
Will continue topping up the water. This way any air bubbles will be displaced
Perhaps the loop is to restrictive for the d5 since you mount the rad on top

Did you try turning to speed 3 and then speed 5 for a few times.
This would help

This post has been edited by sam sam: Dec 23 2012, 07:24 AM

u need a fan controller that can output 3A per channel then you can use it to control the mcp355
also note most fan controller do not output 12volts at full load its slightly lower around 11.3 volts