asked my hobby store boss to get me this and he say YES!!!!


This post has been edited by calcilis: Aug 11 2012, 09:33 PM

i'm a persona 3 and 4 fan so is natural
i already have the normal version and metis
but too bad i fail to get the heavy equipment Aigis

This post has been edited by calcilis: Aug 12 2012, 11:14 PM

my revoltech joint are stiff
and becuz of that i cannot swiver the head
is there anyway to fix that? with carefulness
cuz it seems easy to break the joint

it did not broke yet cuz i'm too afraid to turn it
its white

This post has been edited by calcilis: Sep 18 2012, 05:33 PM

yes its the peg.. that connect to the hole some how is very stiff

sure thx for the help , and btw is there any way to get spare joints?

i checked the internet and my friends and found 2 possible ways of dealing with stiff joints in figma and revoltech
option.1
use hot water(not boiling hot but hot enough that it wont burn ur hands)
all u need to do is just put the stiff part there for like 5~7 sec and pull it out
but b4 moving the joint u need to wait another 5 sec or else u might ruin the hole for the peg
drawback is the water+heat might ruin the paint of ur figurine

option.1
use hairdryer
just put the part in ur hand and use hairdryer to heat it up , and again to heat must not cause pain to ur hand or it might damage the part
drawback is it might not work

b4 i do anything to the stiff joint , i want ask is those method ok or no go?