But ori cps n ori mivec horsepower was much different.so for me d cps onli consider half mivec lo..

---

Added on October 19, 2011, 9:06 pm

I onli wil do pnp and polish throttle body on next yr lo.minor modify onli

BTW, what happened to the car sticker? Even LYN T shirt came out already.
http://store.lowyat.net/apparel/shirts.html

pnp throttle body his father cannot see from outside mah.....

need save money 1st lo..hehe

---

Added on October 19, 2011, 9:59 pm

polish and rebore throttle body is RM90..at dori dori which locate at shah alam..specialities to modify campro

so cheap? that workman kungfu ok or not de o? later jadi ubi kentang... mati lar...

i'm in melaka, to far to get from you, i get from vccy maganetik

Hmm..
My next service should use magnetec or edge?

I'm posting reply on the move.. Rains like the sky is having the best orgasm it ever had.. Fark jam wei

mana gf?

---

Added on October 21, 2011, 11:46 pm
Do u have exhaust mods? With the kind of money u're spending on a quality TB.. Mod extractor & full setup better.. Save petrol samore..

full extractor might not gain the amount of 1 bigger TB changed. 

then dun u think it's a good time for u to try performance oil filters?

Juz came bec from muar tis morning.at d road which from muar to melaka,was tried race wit 2 persona.first one looks like ori,juz change 15inch rim.when speed at 120,i let it pass 1st then juz chase it.i can follow easily and overtake it after 170.test few time oso same.2nd is modify exhaust n 15inch rim.start from 60kmh,it at front of me n he was rev to speed.then i juz follow..until 130 i juz manage can follow but i can it was powerful.after 130 then got car block oledi..then at traffic light,i was behind of it.once green light then i juz follow to pick up.d pick up can easily drag me around half car distance.both persona is old version persona,not pe.i not sure is auto or manual lo.

This morning make a last minute decision to do 15k(mile age 18k) service car at one of the authorise SC at puchong, Trisilco Auto Service Sdn. Bhd. when arrive there are only i PE puoring engine oil, and i just walk in the SA ask me got appointment or no, i sad tarak, he said next time must make appointment and this is the proton procedure,......but that time no car he still wellcome me lah, use synthium 800 10w-40 @ rm103.

Two of the mechanic looks like new but still got 1 senior and the supervisor guided them service my car and teach them step by step, including how to jack up my car, one of the good thing at the SC was you can sit infront of your car watching the service job, so total 4 mechinic serve my PE service job thework done very quick all 4 of them checking the different item at the same time, after jack up my car 1 of them drain the oil others 3 use spanner to check all the bolt and nut, and etc. inspection, all 3 of them like making round and round unde the car, ...

The one of the junior found my car got white colour thing came out and ask the senior " apa ni "  he said "itu foam lah ...lepas inject kereta senyap, aku punya wira pun ada buat"    total job finish 45 min including generate report and payment   

btw found that original PE head lamp price rm307.37 per side only
[attachmentid=2498611]

also see one new PE base line now using Silverstone tyer  ,
[attachmentid=2498615]
the front door rubber to prevent hitting others car when open also become different aldy, now square insted of round, for back door not provided.
[attachmentid=2498616]
finally the sc give me a gift.  
[attachmentid=2498620]

save petrol = human foot matters, not car punya "foot".

Cannot tahan already.. Goodnight fellas~

Safety for cheongster..

Only saw hair flying all over. Taiwan mali?
Where u going? Outstation trip?
Can pin up at first page.

I only can afford telur busuk to put in my maggi.. So sad..
Eh come tetris battle again.. haha..

---

Added on October 23, 2011, 9:46 pm

Ini jepun mali punya...

how to mod the boot gas strut in a way that it will allow shutting of the boot lid nicely rather than slamming shut????? i have handled cars with boot lid struts and bigger sized boot lids and it does not SLAMMMMMMM like how Persona's do.

and btw, to those who do mods to their Persona engine like exhaust or especially air intake to aftermarket, please be advised to "refresh" / "reset" your ECU by unplugging the battery and leave it disconnected for half an hour or more and plug it back in.

i myself first hand experienced it this month. I replaced the intake to aftermarket panel filter by Simota / Works Engineering and i did not really felt the difference. Soon, my car got more and more less responsive, less power and the automatic gearbox got very sluggish. My fuel consumption got from bad to worst. I then wondered what happened to it and tried to think of the possible causes.

I then figured, ok try "reset" the ecu by unplugging the battery terminal. Plugged it back more than an hour later, guess what? I got my car back! Now, i can just "tap" on the throttle to get moving and the car is light again. I got back the all the performance.

So........lesson learn!

---

Added on October 24, 2011, 1:37 pm

yup. it does not need to be slammed. I am referring to as in you cannot close the boot lid without assisting it. meaning when its close to closing, need to hold it a bit and let go. Or else it will go banggggg!

Kinda suck if compared to other exact design boot lid with gas struts. Other makes i can just continue pushing the lid down from start to finish and it wont slam.

Change the hydraulic suspenders.. And add a stopper..
The ECU reset part is normal. Esp. if u mod extractor. U have to do it, & u have to clear the error codes. But most ppl Jz tend to ignore it until something happens.

guys wanna ask you all something about my 2 months old PE.

the central door lock.

very irritating lar.

everytime when i open the door to take my parking ticket or drop off someone and when i close back the door, it will auto lock itself.

i prefer to lock my car door manually rather than auto-lock.

can i over-ride the system?

i ask those sc guys and they say cannot over-ride wor.

anyone here got solution to this irritating problem?

pulll the handbrake... or dont press the brake.. the car wont auto lock lo

That's the abs module la

even this thing fitted to my bro iswara, his car installed VR4 rear disk..so the shop also installed this into the braking line, so far never locked even on hard braking 

Can, but cost wise?

U're just lucky u din face any prob without resetting ECU.. Lol..

I feel the mother's pain...

The little girls was dead last Friday morning

More also will become worse because coolant is used to lube, higher boiling point and lower freezing point. water is there for the high rate of heat transferred which is around 4.2kJ to raise 1c per kg. Just like if u use pure coolant, your engine will have hard time transferring heat to radiator, pure water will cause inner corrosion and maybe long time, pump damage. Its best to follow the coolant spec which usually in every bottle they got state how many ratio of coolant:water needed to ensure cooling system efficiency.

---

Added on October 24, 2011, 8:11 pm
Argh.. sakit..
See the timing la. I okay wan geh.

How often you guys change the wiper? Do you change the rubber whole the whole wiper? Got any good brand to recommend? And what size?

My wiper don't know what problem, everytime i try to spray water to clean the dust the wiper will wipe 1st before water spray, so during dry wipe the whole glass & wiper vibrate until my windscreen got several wiper scratches... Is it the rubber distorted or the wiper is mounted too tight to the glass? How to solve this?

after play siham still semangat go TT?

if me, I sleep liao lu