I think for ppl who have Xbox (FUZA),
PS3 (GT5)....

you may differentiate the class there when you select your favorite MOTOKAR.... LoL

---

Added on October 31, 2011, 10:03 amthe Hardware shop locksmith dam funnly...
first question is

"original not good meh, y want to change? you sure this can fit your car's key hole not......... the quality very lao yah, too thin...."
I was dam heat, orang kasi bizness lagi mau cakap banyak...

after he patahkan my key, I go opposite shop. Lucky she said can fix, but need time to modify (PHEW).
using normail proton key set to duplicate, and cut off the "head" and grind it slowly.
RM32 she charge me. i think a bit expensive, but nvm lah... as long as she can settle, less headace for me.

This post has been edited by kennypotatoes: Oct 31 2011, 10:03 AM

FORZA lah!... LoL...

Fuza is the custom made body kit shop at Klang.. hahaha...

syn 3000 i think almost RM350++, or maybe more....

dugung also good car, FC good mah!!!

my fren goes CITY, she say lancer too bulky. not suitable for gal...

than i 'Cha' her on 90K price, she reply nevermind.

than I said, new Myvi is good..
she replies, aiya, don wan local brand lah, and too small, no power...

i congrate her city is very good car.

conclusion = "buy brand mah buy brand loh, talk so much to pijak proton n perodua..."

really kena poison......
Bro Kenny, how the cable look like?
maybe i can check with my fren....
else get one better.

RPW Reflashed ECU
1.8 MT
1. Kennykl82
2. NZH0920
3. oscar
4. T630
5. usj101
6. Pip_X
7. kaizou
8. Stewpik
9. lazyboy666
10. POTATOES Huat ar...

1.8 CVT
1.

2.0 CVT
1. Satria89
2. matkela
3. sleed
4. ikeken

no lah.. my is Manual...
klang less trafic.... suit me..
i experience some traffic at KL also. not that worse with our clutch..

just sometimes confuse...
driving auto, manual, and classic 4 gear manual.

u know classic car when u do reverse gear, got to lift the gear stick up. sometime i do it in Inspira... and i laugh at myself...hehehe

Taikor.... saya MANUAL juga... ada batang punya...

1.8 MT / CVT
1. K3nnYkl82
2. nzh0920
3. oscarsmh
4. T630
5. usj101
6. Pip_X
7. kaizou
8. Stewpik
9. lazyboy666
10. Potatoes

2.0 CVT
1. Satria89
2. matkela
3. sleed
4. ikeken
5. XCinspire
6.
7.
8.
9.
10.

there's a Penang guy custom made.....
what do you guys think??

Voltage Stabilizer (70,000UF)
-Increased Torque at Low & Middle Speeds.
-Stabilized ldling & Improved Engine Kick Over.
-Improved Engine Response.
-Increased Head Light Brightness.
-Improved Fuel Economy.
-Improved Audio Quality.
-Improved Battery Life.

Cover use Aluminum alloy Hard & Strong.
Inside 35pcs Capacitance (70,000UF)
20Amp Fuse
7 day Money Back Warranty.



电子整流器的工作原理是通过其并连于汽车电瓶上正负极的独立电路系统，在电器系统负荷较小时，将富余的电荷蓄集于整流器内，在电路负荷突然增大时，快速的释放出蓄集的电荷，以稳定电流和电压，保证用电系统的稳定工作及保证引擎动力输出的流畅性。
一　提升引擎扭力。
二　提升油反应　
三　改善燃费　
四　净化废气　
五　稳定及改善大灯及用电设备的电压。
六 减少对电子产品造成的负荷　
七　减少音响杂音　
八　延长电池寿命。
所以一般车都可以加装!!


http://ist1-4.filesor.com/pimpandhost.com/.../pict0407_m.jpg

http://ist1-4.filesor.com/pimpandhost.com/.../pict0298_m.jpg



为什么我们产品会比市场贵？？
-电路板加多一层树脂胶，完全防水、防震、防尘。（别家没有）
-70,000UF的整流器就采用了7种容量，共计35个电容。（别家用7,200的电容而已）
-有保險絲（20Amp）防止發生短路現象。（别家没有）
-外壳采用铝合金（Aluminum alloy） ，使其散热更好。（别家用塑料壳，散不出热来）
-7天内不满意，扣除远费后，原银奉还。（别家没有）
-保修1年 。（别家没有）




现价:RM180<<包邮>>

Dear all,
what about do it RON95 & 97 one shot.

just a suggestion, since beza tiga puluh ringgit shj.

For me, 95 is enough....

I got it from CARI.com... the link that you gave me i think almost the same.. DIY one.. will buy from this guy. Anyone want buy together? maybe can ask him come to install during our TT


Poadster, since you got CARD... map for RON97 lah. enjoy first... dont think too much.. ok...

wait botak only change rims....
rims really cost a lot..

i just try to botak my stock tyres first..
in case one bengkak or pecah. can utilised it kao kao.... (my pocket dry liao mah)

haha.. Kenny, u Sabahan kah?
Meet you up at CNY lah.. haha..

klangster not always FFK one. haha...

R3 without mod performance... still R3 meh... if absorber and spring tukar, break system upgrade than more close to R3.
if body kit only, i think it is just a add-on only. worst than facelift.

then after remaQ by bro Kenny, ours become L3, Lumba, Larry, Lisearch
LoL

come TT u see all these..

This post has been edited by kennypotatoes: Nov 2 2011, 11:03 AM

for me i only like the RIMs given by R3 spec only.

but during changing new 18" tyres, gigi sakit oh...

i think 17 not bad already.... can we say its economic range for our Inspira??!!

cheap also expensive...
save money for milk powder...
plan for 2nd kid.. hahahah....

i still got one classic mini to maintain.
10" cost RM300+++

5000... nak lari kat sepang kot...

Malaysia producing petrol... hybrid is not good time at the moment.

believe the spare parts (batery) are still impose of import tax duty.

not worth...

bring more cash tonight...
new car got to buy us Teh tarik...