Nov 18 2005, 03:06 AM
QUOTE(MacDaNife @ Nov 17 2005, 11:09 PM)
Really?
I bought my jigsaw blades as a set from Ace Hardware. Tried with the wood blade at first. Lots of juddering. Switched to a metal blade and it cuts very smooth. I suspect the metal and acrylic blades are similar - thicker and rather inflexible.
I'll look for the HCS 100-1 blade the next time I'm at Jaya DIY. Thanks for the heads up! All my acrylic cutting is done though. Just waiting for the mobo.
May go with the Asus Dual x16 PCI-e board instead of the DFI... Nice benchies on SLi reported on this baby. Plus it has a neat heatpipe cooler on the NF4 NorthBridge...
most importantly u need to use blades with zero offset. wood blades almost always has offset. guess some metal blades dont have.I bought my jigsaw blades as a set from Ace Hardware. Tried with the wood blade at first. Lots of juddering. Switched to a metal blade and it cuts very smooth. I suspect the metal and acrylic blades are similar - thicker and rather inflexible.
I'll look for the HCS 100-1 blade the next time I'm at Jaya DIY. Thanks for the heads up! All my acrylic cutting is done though. Just waiting for the mobo.
May go with the Asus Dual x16 PCI-e board instead of the DFI... Nice benchies on SLi reported on this baby. Plus it has a neat heatpipe cooler on the NF4 NorthBridge...
ianho... thanks for the tip... i'll check that out.
This post has been edited by MetalZone: Nov 18 2005, 03:11 AM
Quote
0.0195sec
1.29
7 queries
GZIP Disabled