QUOTE(ar188 @ May 19 2015, 10:45 PM)
so thats what u call your wife.. 
Lady boss LYN Power Tools Discussion, Bosch, Hitachi, Milwaukee, Metabo, Hilti
|
|
 May 19 2015, 10:59 PM
Return to original view | Post
#1
|
 
Senior Member
1,609 posts Joined: Sep 2005 From: KL  
|
|
Quote|
|
|
|
|
May 19 2015, 11:02 PM
Return to original view | Post
#2
|
|
Senior Member
1,609 posts Joined: Sep 2005 From: KL
|
QUOTE(idoblu @ May 19 2015, 02:59 PM) I very fail in DIY Have you ever drilled tiles? hang one mirror - two holes only also senget wan Today I was supposed to install my 42in flat screen TV. Only 4 bolts. I measure here measure there. Got use spirit level beam to check level or not. In the end, still senget a bit and one hole, cannot fit the bolt. I already marked the spot where I want to drill. I check and recheck many times to make sure its level everything. Still tabuli.....manyak failed In the end, only 3 bolts holding my TV wall mount. I still got one TV to go.....I sked now  The drill bit will run all over the place. |
|
|
May 19 2015, 11:08 PM
Return to original view | Post
#3
|
|
Senior Member
1,609 posts Joined: Sep 2005 From: KL
|
QUOTE(ar188 @ May 19 2015, 11:00 PM) u also reno house ah? Summary of a long story. Got a contractor to build a roof over my master bedroom and half of the concrete balcony. Redo waterproofing for the entire balcony. Extend master bedroom. Repaint gate and fencing. Ownself do Repaint 3 upstairs bedrooms. |
|
|
May 19 2015, 11:13 PM
Return to original view | Post
#4
|
|
Senior Member
1,609 posts Joined: Sep 2005 From: KL
|
QUOTE(ar188 @ May 19 2015, 11:09 PM) whats the rough cost for this roof and concrete extend bedroom? roof - 15kbedroom with 4 pieces 6 ft windows and grills - 10k |
|
|
May 20 2015, 10:00 AM
Return to original view | Post
#5
|
|
Senior Member
1,609 posts Joined: Sep 2005 From: KL
|
QUOTE(idoblu @ May 20 2015, 05:22 AM) I bought special drill bit for tiles. After I finished two holes, the drill bit became just a metal rod. The tip habis koyak ok this is what I do when I drill tiles.But I was using a normal drill last time. Took very long just to drill two holes 1) select drill function and use a tile drill bit to start off and drill a small hole about 2 mm deep 2) switch to hammer function, change to masonry drill bit and continue drilling If you don't use the hammer function to drill tile, it'll take very long. If you straight away use the hammer function from the start you might crack the whole tile. So I use a combination of both. |
|
Topic ClosedOptions
|
| Change to: |  0.0698sec
 0.94
 7 queries
 GZIP Disabled
Time is now: 1st December 2025 - 08:22 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.