Here is the part 2 Part 2

hmm ... good guide but not so in detail, the guide that gary put up at the front page is even better ..

the part 2 is absolutely bull shit ... there's no guide at all .. just a simply show u the magic.

Vantec kit is good in one sense but poor in another .. most of time u would over spent coz like Rodney said ..

you would need two packs of those to get a PSU done with few excessive sleeves.

So it's much more better if the sleeves are purchase at the size and length needed separately

Besides the heat shrink that comes with vantec could shrink a lot but it's not firm and a bit soft ... good for bending the cable after sleeve but can't hold the cables well.. which why cable tie is used by Rodney in the part 1..

overall I would appreciate the quality of vantec's sleeves but not the heat shrink .... better go for industrial grade .. lot more cheaper, more size selection and holds better ...