Issue 7 - Contains front wheel shafts, upright bases, suspension covers & wing stays; and has instruction for attaching of the front suspension covers & front wing stays to the nose, and attaching the nose to the front wing.

Attaching the front suspension covers - Carefully cut the right and left suspension covers off the sprue, and scrape the paint from the inner (flat) surfaces.

Take the nose section and scrape paint in a small area around the suspension cover mount hole on either side of the nose, check that the covers fit well and be mindful not to scrape paint outside of the suspension cover profile; apply glue and add the suspension covers.

Attaching the front wing stays to the nose - Carefully cut the right and left wing stay from the sprue, note that each stay is marked 'R' and 'L' for the right and left side, and upon installation that the letter faces to the inside.
Gently scrape the paint from the indicated areas of each stay and also from the flat surfaces of the nose where the stays fix to, sparingly apply ABS glue and fix together.

Attaching the nose section to the front wing - Take the front wing assembly and match up to the ends of the wing stays of the nose for a dry fit of the fixing process, then disassemble and sparingly apply ABS glue at the fixing points, and hold the assembly together with masking tape, then set aside for the glue to fully dry.

That's it for this issue, carefully store the nose section and remaining parts.